blcdsources

通过编程实现51单片机的电子表功能，包括时钟、日期、计时、闹钟、倒计时等(Achieve 51 microcontroller programmed Spreadsheet functions, including the clock, date, time, alarm clock, countdown, etc.)

说明：  通过STM32单片机驱动红外温度传感模块MLX90614(Driving infrared temperature sensor module MLX90614 by STM32 single chip microcomputer)

基于msp430单片机的液晶12864的驱动程序简单。。(The driver of LCD 12864 based on MSp430 MCU is simple.)

说明：  控制器汽车悬架主动控制rts2800_fl040830---烧写(controller)

说明：  ltc6811的使用配置程序，可以直接使用。(ltc6811,SPI use,can directly use)

atmega128+tda7330B+tef607实现RDS(atmega128+tda7330B+tef607 to realize RDS)

带主动两轮主动差速的双电机PID调速模块，实现对电机的调速，尤其可以适用于对后轮双独立电机驱动方式的主动差速调节。(The dual motor PID speed regulation module with active two wheel active differential can realize the speed regulation of the motor, and can be applied to the active differential regulation of the driving mode of the dual motor of the rear wheel.)

ds1994一线通讯协议 ds1994一线通讯协议(ds1994 front-line communications protocol the ds1994 first-line communications protocol)

在stm32f103zet6下的485总线通讯加modbus协议(485 bus communication and Modbus protocol under stm32f103zet6)

真空机组先启动SK-30水环真空泵带压力降到6.5 KPa（此时真空机组的抽速是SK-30的抽速）启动ZJP-1200（此时真空机组的抽速是ZJP-1200抽速）待压力降到4 KPa启动ZJP2500（此时真空机组的抽速是ZJP-2500抽速）待压力降到1kpa时最后启动ZJP5000（此时真空机组的抽速是ZJP-5000抽速）到100Pa达到使用真空度时时就可以关闭机组(Vacuum unit first start SK-30 water ring vacuum pump with pressure drops below 6.5 KPa (pumping speed of the vacuum unit at this time is SK-30 pumping speed) start ZJP-1200 (pumping speed of the vacuum unit at this time is ZJP-1200 pumping speed ) until pressure drops below 4 KPa start ZJP2500 (pumping speed of the vacuum unit at this time is ZJP-2500 pumping speed) until the last start when pressure drops 1kpa ZJP5000 (pumping speed of the vacuum unit at this time is ZJP-5000 pumping speed) to 100Pa achieved using vacuum unit can be closed from time to time)