-
Spiht2004-04-26
SPIHT图像压缩编码的Matlab程序。(SPIHT image compression encoding procedure of Matlab.)
- 2009-04-12 20:16:29下载
- 积分:1
-
code
分别用改进的Euler方法和四阶Runge-Kutta方法求解。
(Were improved Euler method and fourth-order Runge-Kutta method.)
- 2009-06-29 13:17:41下载
- 积分:1
-
FM_phase_noise_1
The file calculates and plots FM noise sidebands for a carrier. It also does sinusoidal modulation. This simple way of adding noise to a carrier is useful for simulation of PLLs. It turns out, though, that the mean of the randn function is not as close to zero as it could be, and this causes the fft to generate extra sideband energy, which makes it appear as if the noise is not what would be expected. This program gets around this by adding a fudge factor to the randn results to eliminate this problem. It took me ages to figure this out, I hope to reduce a similar effort for others
- 2011-07-20 21:08:11下载
- 积分:1
-
time-series-method
基于时间序列法的风电预测matlab程序,可根据已知数据预测未来的风电功率。(Method based on time series prediction matlab program for wind power, according to known data to predict the future wind power.)
- 2013-10-06 16:16:00下载
- 积分:1
-
NSGAⅡ
说明: 利用NSGAII算法进行对复杂网络的社区检测(community detection in complex network)
- 2020-03-12 23:55:05下载
- 积分:1
-
Fixed_point_Signal_Processors
Fixed Point Implementation Basics, a practical usage guide.
- 2012-09-11 03:54:08下载
- 积分:1
-
getJavaNum
获取每天的代码进度
自动与之前的进行对比
带gui
可以设定文件位置(Access code progress every day)
- 2015-04-05 15:31:03下载
- 积分:1
-
diancibo
有限差分法实验报告
用Matlab中的有限差分法计算槽内电位;
对比解析法和数值法的异同点;
选取一点,绘制收敛曲线;
总的三维电位图(Finite difference method for the experiment report
Matlab finite difference method for calculating the slots in the potential
Comparative analytic method and numerical method the differences and similarities between
Select a bit, draw convergence curves
General 3 d potential figure
)
- 2012-04-12 23:42:35下载
- 积分:1
-
li1
请用多层感知器(MLP)神经网络误差反向传播(BP)算法实现异或问题(输入为,要求可以判别输出为0或1),并画出学习曲线。其中,非线性函数采用S型Logistic函数。(Please use the Multilayer Perceptron (MLP) back propagation neural network (BP) algorithm XOR problem (input is required to determine the output is 0 or 1), and draw the learning curve. Among them, the non-linear function using S-type Logistic functions.
)
- 2014-09-21 15:28:12下载
- 积分:1
-
AC_toAC_1I
this file is an ac to ac controller.
you can control the output by adjusting the firing angle of the SCR.
- 2013-12-20 14:21:52下载
- 积分:1