UCOS2+UCGUI+KEIL_C51

本程序主要的功能是通过PWM来进行光的亮度的调节(The main feature of this program is carried out by the PWM brightness adjustment of light)

说明：  基于光敏电阻的路灯控制电路。在单片机的基础上，用光敏电阻控制led亮灭。(Street lamp control circuit based on photoresistor. On the basis of MCU, the LED is controlled by photoresistor.)

单片机音频通信9170和9200，接收发送源程序(9170 and 9200 microcontroller audio communication, the receiver sends source)

12C5A60S2 EEPROM 的读写操作(12C5A60S2 EEPROM read_write)

基于pic16f676 EEPROM的问题 用软件仿真没问题，但烧到片子里，不能正常运行。情况是这样的：假如循环向EEPROM中写数据，9，8，7，6，5，4，3，2，1，然后读，发现每一位读出的都一样，是写循环中第一个写进去的字节，也就是9。其他的并没有写进去。 EEPROM的写通过判断标志位就可以，但是在下一次写之前要清除上一次写完成的标志位。也就是说，每次写完要清除完成标志位，否则下一次写不进去。(Based on pic16f676 EEPROM problem With the software simulation no problem, but burn to film, not normal operation. The fact of the matter is: if cycle to write the data of EEPROM, 9,8,7,6,5,4,3,2,1, then read, and found that each of the read, write the first cycle is written in bytes, also is 9. The other are not written in. Write through the judgement of EEPROM sign a can, but in the next write to remove the last completed before writing the sign of a. That is, every time to remove the written finish marks a, or the next write in. )

c8051f040单片机通过控制L298驱动两相四线步进电机程序(c8051f040 L298 driver chip by controlling the two-phase four-wire stepper motor program)

这是LPC1114单片机的I2C总线的程序，程序已可以运行，txt版文件。(This is a program LPC1114 microcontroller I2C bus, the program has been run, txt version of the file.)

Si4313 无线遥控接收程序，和Si4010 遥控程序配合(The Si4313 wireless remote receiving program, and Si4010 remote control program with the)

ATMEGA48 头文件 适用于 ICCAVR7.0 有些版本没有ATMEGA48的头文件(ATMEGA48 )

protues的教程，初学者的必备，可以学习很多东西，对自己收益很大(study protues)