crystal01

说明：  安富莱modbus教程，源码讲解，希望能够帮到大家。(Anfulai modbus tutorial, source code explanation, hope to help you.)

《单片机C语言程序设计实训100例—基于8051+Proteus仿真》案例(failed to translate)

eye controlled wheelchair using fourier transform

These are some useful documents that can help to understand permanent magnetic synchronous generator (PMSG)

基于PSCAD/EMTDC搭建的CIGRE HVDC改进模型，仿真电压、电流图形比原模型的波形要稳定。(Based PSCAD/EMTDC built CIGRE HVDC improved model simulation voltage and current waveforms graphics than the original model to be stable.)

Proteus画的51单片机超声测距并仿真。(Proteus carry out the ultrasonic measure distance circuit using 51SOC and simulate。)

利用51单片机的汇编语言来实现0到15V稳压电源的实现功能。(51 microcontroller using assembly language to achieve the 0 to 15V power supply to achieve function.)

说明：  基于MSP430F5438A的AD9854驱动，AD9854的DDS核具有48位的频率分辨率（在300M系统时钟下，频率分辨率可达1uHZ）。输出17位相位截断保证了良好的无杂散动态范围指标。AD9854允许输出的信号频率高达150MHZ(Based on the AD9854 driver of MSP430F5438A, the DDS core of AD9854 has a frequency resolution of 48 bits (up to uHZ at 300 M system clock). Output 17-bit phase truncation ensures a good dynamic range index without spurious. AD9854 permits up to 150 MHZ of output signal frequency)

基于STM32 的 LD3320基本驱动程序,能够识别语音命令去控制执行命令。(LD3320 basic drivers based STM32, able to recognize voice commands to control execution of the command.)

说明：  此程序是使用ADXL345三轴重力传感器和433超再生无线模块结合，在重力感应下，通过发射模块将方向信号发射给接受模块，从而控制小车的方向。(This program uses adxl345 three-axis gravity sensor and 433 super regeneration wireless module. Under the gravity induction, the direction signal is transmitted to the receiving module through the transmitting module, so as to control the direction of the car.)