xi1

（1）离散余弦变换DCT基底灰度图像绘制（2）离散傅里叶变换DFT基底灰度图像绘制((1) discrete cosine transform DCT base gray image rendering (2) Discrete Fourier Transform DFT basal gray image rendering)

the sum-rate inner bound of sason on two-user interference channel

SVM multi classifier with diferent Kernels example

一束光通过一个透明圆柱体，圆柱后有一个屏幕，程序最终反映屏幕上的 图象随圆柱半径的变化而变化。其中光强分布是采用相干叠加原理，因为其中采 样点数目不足，所以光强分布的结果和真实的有一定差距。增加采样点数目和改 变采样点范围能够改善输出光强的结果逼真程度。(一束光through a transparent cylinder, a cylindrical post-screen process will ultimately reflect the on-screen image with the cylindrical radius change. Light intensity distribution of which is the principle of coherent superposition, because the insufficient number of sampling points, so light intensity distribution of the results and have some real gaps. Increase in the number of sampling points and to change the scope of sampling points can improve the outcome of the output light intensity the degree of realism.)

说明：  dsp相关的matlab程序，有很多哦， 很有用的(dsp procedures related to the Matlab, many Oh, very useful)

设计低通数字滤波器，要求在通带内频率低于 时，允许幅度误差在1dB以内，(Design of digital low pass filter, requirements in the passband frequencies below, allow a margin of error of less than 1dB,)

积分方程的数值解（matlab代码）利用MATLAB求解积分方程的数值解问题(The numerical solution of integral equations (matlab code))

This report considers trajectory planning with constrained dynamics and design of an appropriate feedforward controller for single axis motion control. A motivation is given for using model-based fourth order feedforward with fourth order trajectories. An algorithm is given for calculating higher order trajectories with bounds on all considered derivatives for point to point moves. It is shown that these trajectories are time-optimal in the most relevant cases. All required equations for third and fourth order trajectory planning are explicitly derived. Implementation, discretization and quantization effects are considered. Simulation results show the superior effectiveness of fourth order feedforward in comparison with rigid-body feedforward

蜂窝小区资源分配，根据小区间干扰对部分小区进行限制，分配功率和频率资源，实现吞吐量最大化。(Cell resource allocation, according to the inter-cell interference on the part of the cell to limit distribution of power and frequency resources to maximize throughput.)

北工大matlab电子课件，陆续还有好多，很全的，希望大家下个痛快(err)