matlab信号处理源程序2

二次规划的matlab源代码，很有用的优化工具！(Quadratic programming matlab source code, very useful optimization tool!)

说明：  matlab环境下，计算圆极化电磁波轴比的程序(calculated circularly polarized electromagnetic wave axis than the program Matlab environment)

matlabGUI设计的一个简单的例子，实现的图像的阈值的自动调节，然后输出阈值化后的图像，(A simple example matlabGUI designed to automatically adjust the threshold to achieve an image, then the output image after thresholding,)

应用模拟退火的TSP优化算法，程序注释清晰，运行流畅(The TSP simulated annealing optimization algorithm, the program notes clear and running smoothly)

相控阵MIMO雷达仿真图，对于雷达的仿真(Phased array the MIMO radar simulation diagram for radar simulation)

睁闭眼信号的处理，welch方法和功率谱(Open eyes closed eyes signal processing, welch method and power spectrum)

本程序是现代谱分析中的clean的matlab程序，经过仿真验证，获得较为准确的结果。(This program is clean modern spectral analysis of the matlab program, through simulation, to obtain more accurate results.)

LOCAL BINARY PATTERNS

Dijkstra算法，在通信过程非常重要的一个算法，这是它的MATLAB仿真程序。(Dijkstra algorithm, the communication process is very important algorithm, which is its MATLAB simulation program.)

说明：  本文正是在研究WIMAX/802.16e协议和FMIPv6协议的基础之 上，提出了基于FMIPv6的WIMAX网络快速切换机制，该方案采用跨 层切换的思想，MAC层联合网络层同时进行切换，在链路尚未断开 之前即完成新转交地址(NCOA)获取等功能，从而加快了切换进程， 减小了切换时延和切换时的丢包率。在提出本切换机制的基础上，本 文在NSZ仿真平台上对所提出的切换方案做了系统性的性能仿真，通 过仿真结果验证了方案的可行性和优越性。 ( In this paper, IEEE802.16e standard is described at first. Then an introduction for the basic knowledge and research in MIPv6 and FMIPv6 protocol is given. A fast handover scheme of WiMAX network which based on FMIPv6 protocol is suggested, which implements the fast handover at IP layer associating with MAC layer at the same time. scheme minimizes handover latency by predicting and preparing This the impending handover in advance. Finally, simulation are carried out to evaluate the performance of this fast handover scheme. The result of the simulation shows that the fast handover scheme has good performance. )