cbf

径向基函数（RBF）神经网络在分类中的应用(Radial Basis Function (RBF) neural network classification)

灰色模型 gm(1 1) 二次拟合 matlab (gm（1，1）matab)

基于stbc编码的ofdm结合mimo信道传输系统仿真(Combination of coded ofdm based stbc mimo channel Transmission System Simulation)

光顺MATLAB中画出的曲线，相当于Excel中的拟合曲线的功能(Fairing draw curves in MATLAB)

This is the file for permanent magnet synchronous generator for sliding mode operation.

　提高电源的动态响应　　非线性和复杂的系统是一个转换器　　电力电子的有趣的挑战。摘要介绍了　　设计和实现数字PID控制器使用　　混沌粒子群优化(复)提振　　转换器,提出了自动调优转换器的方法　　最优启动响应。当系统启动时,处理器　　单元分析了开环启动响应转炉和　　在一些迭代使用复准备最佳反应　　算法。使用逻辑映射混沌映射序列　　增加它的收敛速度和精度。模拟　　和实现结果显示提出的效率　　方法(Improving dynamic response of DC-DC converters which are nonlinear and complicate systems is an interesting challenge in power electronics. This paper presents the design and implementation of digital PID controller using the chaotic particle swarm optimization (CPSO) for a Boost converter and proposes an approach for auto tuning converter optimum startup response. When the system starts, processor unit analyses the open loop startup response of converter and prepares optimum response during some iteration using CPSO algorithm. Chaotic mapping using logistic map sequences increases its convergence rate and resulting precision. Simulation and Implementation results show efficiency of proposed approach)

System Identification s matlab program

说明：  粒子滤波算法与扩展卡尔曼滤波算法的比较方法。(Particle filter and extended Kalman filter algorithm for comparison.)

这是CISS会议上发表的著名论文“Tensor Canonical decomposition based method for blind identification of MIMO system with 3-input 2-output case”的源程序，主要是讲基于张量规范分解的多天线系统的忙识别问题，里边包含了相应的文章，可以一起对照着看。(conference on the famous treatise "Tensor Canonical deco mposition based method for blind identificati on of MIMO system with 3-input 2-output case, "the source procedures, primarily based on stress tensor decomposition of standardized multiple antenna system to identify problems in the 1980s, contained inside a corresponding article, can work together to look to see.)

真的好有用 啊 求ＤＮＡ模型的ＭＡＴＬＡＢ代码(it is really good very goood )