-
GUI
gui编程实例,内含35个实例,并有pdf说明介绍各例子(35 matlab examples of GUI)
- 2011-06-30 10:13:09下载
- 积分:1
-
AplikasiPenilaian
Aplication values with NetbeansIDE
- 2014-11-27 12:09:33下载
- 积分:1
-
Kalman
捷联惯导初始对准Kalman滤程序,非常难得的代码源程序。(SINS initial alignment Kalman filter program, source code is very rare.)
- 2011-12-26 18:47:21下载
- 积分:1
-
pde3
partial differential equation 3 matlab
- 2010-02-06 01:01:25下载
- 积分:1
-
RC
说明: 一阶RC低通滤波器与二阶RC低通滤波器特性分析及其阶跃响应对比(First-order RC low-pass filter with the second-order RC low-pass filter characteristics of its step response comparison)
- 2010-05-22 08:57:00下载
- 积分:1
-
fangdaqi
由于一般的功率放大器不是线性的,且动态范围是有限的,所以当OFDM系统内这种变化范围大的信号通过非线性部件时,信号会产生非线性失真。(
As the general power amplifier is not linear, and the dynamic range is limited, so that when a large range of variation within an OFDM system, the nonlinear signal components, the signal will produce nonlinear distortion.)
- 2014-08-17 12:14:32下载
- 积分:1
-
boundary_conditions
在emd中处理边界用到的一个程序,效果很不错。(Treatment of boundary in the emd used a program, the effect is very good.)
- 2014-09-17 19:17:39下载
- 积分:1
-
SFLA-LSSVM
自己编写的
混洗蛙跳算法优化最小二乘支持向量机参数
把文件里的数据、LSSVM模型更换,就可以移植(written by Son.Y.M
Shuffled frog leaping algorithm to optimize the parameters of LS-SVM
The data in the file, LSSVM model replacement, you can transplant)
- 2015-05-04 20:53:35下载
- 积分:1
-
adhoc
在仿真中,我们规定每个移动节点的发射功率是常数,PTx = 1W;接收节点接收机的灵敏度Smin = -80 dBm;信号质量 min = 2 dB;系统的背景噪声门限INThre = 1.2e-10(In the simulation, we require that each mobile node s transmission power is constant, PTx = 1W receiver node receiver sensitivity Smin =-80 dBm signal quality )
- 2008-02-21 23:13:25下载
- 积分:1
-
BlkLanCom
说明: 生成复杂矩阵,利用lanczos算法。不知道说什么了(Generate complex matrix, use lanczos algorithm. Do not know what to say)
- 2010-04-14 20:23:43下载
- 积分:1