GAdisplacement

说明：  倒立摆实验，有关大学现代控制理论中的实验内容(Inverted pendulum experiment)

说明：  这个Matlab环境下的模式分类算法集提供了二维两类分类问题的很多可视化程序(the Matlab environment under the classification algorithm provides a two-dimensional set two classifications of many visual programming)

说明：  PSO优化算法优化多变量没别的了，就这样了了了了了了(PSO optimization algorithm)

该程序包实现了VBLAST结构的传输下，接收端采用ZF、ZF_SIC、MMSE、MMSE-SIC等检测算法时误码率和信噪比的性能比较(The package implements the transmission of VBLAST structure, the receiver with ZF, ZF_SIC, MMSE, MMSE-SIC detection algorithm for error rate and SNR performance comparison)

在MATLAB中用M文件编写来实现四种不同的单神经元控制器(realize single-neurons PID Controller in MATLAB)

针对OFDM系统，分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度，采用链路级仿真的部分结果。(It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation. System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate. Link-level simulator support SISO, 1 by x MRC, 2 by 1 STBC/SFBC, 2 by 2 Alamouti, x by 1 Antenna selection, x by y antenna selection. System-level simulator, currently support only SISO and 1 by 2 MRC. To start with, go into the folder sys_link_simu, and excute the following commond from matlab: sys_link_simu_func(a,b) where a is the link ada)

这个程序既有发送端的程序又有接收端的程序，仿真非常通顺，很具有借鉴意义(OFDM RECEIVE AND OFDM SEND SOURCE CODE)

基于matlab的水印技术，程序书写的规范，功能齐全(Watermarking technology based on MATLAB, program writing specifications, complete function)

FAST corner detector

总结了最基本和最常用的mattlab源码，很实用(Summarizes the most basic and most common mattlab source, it is practical)