Code

使用VC对并口进行访问和控制的VC程序示例，该程序完全用API完成(parallel to the use of VC visit and control procedures VC example, the procedure is totally complete with API)

说明：  网络芯片ch563读写u盘例程，例程完整，方便开发(The network chip ch563 reads and writes the U disk routine, which is complete and convenient for development)

采用labview编写的I2C通信程序，几乎可以通用的喔(prepared by the I2C communications procedures, almost generic oh)

MATLAB环境下对turbo编码进行仿真模拟，并对误码率做出分析(The MATLAB environment MPFK modulation simulation, and error rate to make the analysis of)

此文件为一仿真机的压缩文件，主要是针对解决光通信系统里面传输过程中的非线性补偿而写的代码，可以有效的补偿光在光纤里面传输的非线性。(This file is a compressed file of an emulator, which is mainly written to solve the nonlinear compensation in the transmission process of the optical communication system, and can effectively compensate the nonlinearity of light transmission in the optical fiber.)

注水算法，经典注水算法在MIMO自适应资源分配中功率分配的最优算法(water filling algorithm)

使用matlab中的通信工具箱中simulink搭建直接序列扩频系统并进行仿真，(The direct sequence spread spectrum system is built and simulated by using Simulink in the communication toolbox of MATLAB.)

线性调频信号和相位编码信号（七位巴克码）及他们的混合调制信号在matlab中的实现(The realization of the chirp signal and the phase-encoded signal (seven Barker code) and their hybrid modulation signal in matlab)

D2D的自适应链路仿真，可根据信道状态，自选自调制方式(D2D adaptive link simulation, according to the channel state, optional self modulation)

this book describes hwo to chose optimal training sequence for an efficient mimo channel