space_vector_modulation

排队论的最基本模型，MM1型。简单的小程序，注释清楚，方便理解。(The most basic model of queuing theory, MM1 type. Simple procedure, comments clear, easy to understand.)

This contains the genetic algorithm permutation and radial basis function

利用MATLAB编程实现遗传算法，并结合一维多峰值函数对算法性能进行了测试，在MATLAB环境中采用遗传算法有效地解决了求解函数的优化问题，仿真结果验证了该算法的有效性，图像直观，性能优越，为遗传算法的实际应用开辟了新的途径和渠道。(Genetic algorithms using MATLAB programming, combined with a function Victoria Peak performance of the algorithm was tested in the MATLAB environment using genetic algorithms to effectively solve the problem of solving function optimization, simulation results verify the effectiveness of the algorithm, the image visually superior performance, the practical application of genetic algorithms has opened up new avenues and channels.)

参考Matlab提供的模块建立简化的三相锁相环的仿真模型，只保留必要的步骤，如abc-dqz只计算Vq，去除频率反馈模块和自动参数调整模块等。 建立单相锁相环的计算模型  简化单相锁相环的系统结构，保留必要的PI控制器等模块  验证并讨论输入信号频率在45-65Hz变化时设计的锁相环的动静态性能  仿真并分析三相输入信号包含谐波、不平衡和直流偏移时锁相环的锁相结果(Reference Matlab provides three-phase PLL module to establish a simplified simulation model, retaining only the necessary steps, such as abc-dqz counting only Vq, remove frequency feedback module and automatic parameter adjustment module.  simulation and analysis of the three-phase input signal contains harmonics, unbalance and DC offset PLL phase-locked Results)

说明：  非常全的GPS-MATLAB源代码，其中有很多的小程序，便于读者使用(Very full of GPS-MATLAB source code, many of them small program, easy to readers to use)

matlab 求解方程组 计算方法 数值分析(calculation methods to solve equations matlab numerical analysis)

dijkstra输入邻接矩阵，起讫点，输出最短路径(This function is built on the dijkstra.m function written by Jorge)

高阶谱分析包，应用范围包括阵列信号处理，盲源信号处理等(higher order spectral analysis package, including the application of array signal processing, blind signal processing)

Solves the incompressible Navier-Stokes equations in a rectangular domain with prescribed velocities along the boundary. The standard setup solves a lid driven cavity problem.

用matlab编写的，有限元三维梁单元的单元刚度矩阵计算程序，各节点6个自由度。(prepared by the three-dimensional finite element beam element of the element stiffness matrix calculation program, the 6-DOF nodes.)