Matalab

在NX平台上，利用二次开发工具创建孔、型腔、边倒圆，并进行相对定位(On the platform of NX, using NX second development tools to create a hole, cavity, edge rounding, and relative positioning)

描写了怎么样将c函数直接在malatb中调用的方法 有详细说明(Kind of describes how to c function call directly in the malatb method is described in detail)

GSC based beamforming

Resizing an Image in simulink blocks

说明：  基于simulink 的ofdm仿真，一个完整的系统。用于信道估计仿真。(The ofdm simulink-based simulation, a complete system. Channel estimation for the simulation.)

光伏太阳能电池最大功率仿真模型的实现，(Simulation model of PV maximum power to achieve maximum power MPPT Figure)

全相位FFT（apFFT）时移相位差法多频测试程序，内置5种不同的频率，可以得到很精确的幅值、频率、相位估计，仿真时精度很高。(All phase FFT (apFFT) method when multi-frequency phase-shift test procedures, built-in 5 different frequencies, can be very precise amplitude, frequency, phase estimation, the simulation accuracy is very high.)

说明：  调用normfit函数求正态总体参数的最大似然估计和置信区间(Normfit function calls seeking normal population parameters of maximum likelihood estimates and confidence intervals)

Introduction to the Issue on Cooperative Communication and Signal Processing in Cognitive Radio Systems

电能质量评估程序，很不错的，可以很好的评估，这是典型工况分析(Power quality assessment procedures, very good, good assessment, which is the typical working conditions analysis)