p3

在Matlab simulink环境下编写的在滑模控制模型的四分之一车模型。 经仿真效果很好(In Matlab simulink environment written in the quarter-car model sliding mode control model. The simulation works well)

C++ version (OpenCV) of the Matlab built-in function filtfilt.m.

用matlab7.0软件对通信信号进行调制数字通信系统通信系统调制解调(PL_FSK)VHDL建模,包括发送和接受模块PL_FSK(good)

说明：  这是恒好的代码，请大家好好利用他，谢谢了，我眼下在(This is the constant good code, please make good use of him, thank you, I now in)

Bit-plane slicing Instead of highlighting gray level images, highlighting the contribution made to total image appearance by specific bits might be desired. Suppose that each pixel in an image is represented by 8 bits. Imagine the image is composed of 8, 1-bit planes ranging from bit plane1-0 (LSB)to bit plane 7 (MSB).

位置指令为幅值为1.0的阶跃信号，r（k）=1.0。网络结构为1-4-1，高斯函数的参数值取Cj=[-2 -1 1 2]T ，B=[0.5 0.5 0.5 0.5]T 。 网络权值学习参数为η=0.30，α=0.05 。PID控制各参数的初RBF网络控制，被控对象为G（s）= 取采样时间为1ms，采用Z变换进行离散化，离散化后的被控对象为 y(k)=-den(2)*y（k-1）-den(3)*y(k-2)+num(2)*u(k-1)+num(3)*u(k-2) 始值为，kp=20， kd=0.3， ki=0.1。 (Position command for the step signal amplitude of 1.0, r (k) = 1.0. The network structure is 1-4-1, the Gaussian function parameters taken Cj = [-2-1 1 2] T, B = [0.5 0.5 0.5 0.5] T. Weight learning parameter η = 0.30, α = 0.05. PID control parameters at the beginning of each RBF network control, the controlled object is G (s) = take the sampling time is 1ms, using the Z transform discrete, discretized controlled object is y (k) =-den (2)* y (k-1)-den (3)* y (k-2)+num (2)* u (k-1)+num (3)* u (k-2) initial value, kp = 20, kd = 0.3, ki = 0.1.)

说明：  A*算法，动态路径规划算法的一种，程序直接放到matlab即可运行。(A * algorithm, a kind of dynamic path planning algorithm, the program can be directly put into Matlab to run.)

智能天线中多单元圆形天线阵的波达方向估计(Smart antennas in multi-element circular antenna array of the Direction of Arrival Estimation)

本文详细的介绍了如何利用Matlab仿真来作回归分析(This paper describes in detail how to make use of Matlab simulation regression analysis)

基于matlab的机械故障诊断系统的小波分析，能够加载正常信号与故障信号的数据，进行对比分析，适合初学者学习使用。(wavelet analysis)