safharmonicAPF

基带非线性器，最常用的基带非线性器是幂级数模型和限幅器模型，这里给出的是幂级数模型的。(Baseband nonlinear device, the most common is the baseband power series model and the nonlinear limiter model, where the model is given a power series.)

很实用的光伏并网发电系统模型建模及相关分析。(PV moedl)

并网时检查电网频率和幅值的探测的简单程序(Simple program to check the grid frequency and amplitude detection grid)

信息融合　　使用两个传感器进行航迹融合　　Bar-Shalom-Campo融合算法(ｆｕｓｉｏｎ　　Bar-Shalom-Campo)

IEEE 802.15.3a 多子带OFDM系统物理层仿真链路。基与Matalb R14版本(IEEE 802.15.3a more sub-band OFDM physical layer simulation system link. Matalb R14 version of the base and)

说明：  本文正是在研究WIMAX/802.16e协议和FMIPv6协议的基础之 上，提出了基于FMIPv6的WIMAX网络快速切换机制，该方案采用跨 层切换的思想，MAC层联合网络层同时进行切换，在链路尚未断开 之前即完成新转交地址(NCOA)获取等功能，从而加快了切换进程， 减小了切换时延和切换时的丢包率。在提出本切换机制的基础上，本 文在NSZ仿真平台上对所提出的切换方案做了系统性的性能仿真，通 过仿真结果验证了方案的可行性和优越性。 ( In this paper, IEEE802.16e standard is described at first. Then an introduction for the basic knowledge and research in MIPv6 and FMIPv6 protocol is given. A fast handover scheme of WiMAX network which based on FMIPv6 protocol is suggested, which implements the fast handover at IP layer associating with MAC layer at the same time. scheme minimizes handover latency by predicting and preparing This the impending handover in advance. Finally, simulation are carried out to evaluate the performance of this fast handover scheme. The result of the simulation shows that the fast handover scheme has good performance. )

the program to run example

SVM to control inverter , used emded matlab and smilink plus.

说明：  基于事件触发的多代理控制，基本案例仿真，能够运行哦(Multi-agent control based on event triggering)

说明：  MATLAB GUI设计实例程序（电工）.