16qammontecarol

用Matlab程序实现P阶Levinson-Durbin算法。以一个2阶自回归模型（参数为b0=1, a1=0, a2=0.81）和一个2阶滑动平均模型（参数为b0=1, b1=1, b2=1）为例，选取观测数据长度为1000，分别用一个AR(2)模型和一个AR(10)阶模型来估计其功率谱。设激励信号模型的高斯白噪声的均值为0，方差为1。用Levinson-Durbin算法迭代计算AR模型参数，并用估计出的AR模型参数画出观测信号的功率谱。并对Levinson-Durbin算法的性能进行分析。(Write a small MATLAB program that implements the pthorder Levinson-Durbin (L-D). Run/Test the program using a AR(2) process (b0=1,a1=0, a2=0.81) and an MA(2) (bn=1,1,1) process-about 1000 samples. Use L-D with p=2 (for the AR) and 10 (for the MA). Plot the AR spectra produced in the two cases with L-D. List the direct form and the reflection coefficients in a table. Profile the L-D (total number of computations for a pthorder)

An Introduction to Structural Optimization

应用地球物理学电法勘探对称四级直流电测深matlab程序(Electrical method of applied geophysics exploration symmetrical four DC sounding matlab program)

C语言与MATLAB接口编程实例，主要是一些C语言与MATLAB 接口的程序，希望对大家有用(C language MATLAB interface programming examples, some of the C language and MATLAB interface program, and hope to be useful)

数值分析程序中的一个例子，matlab gui编程(Numerical analysis of an example program, matlab gui programming)

用db5小波分解嗲能质量信号 并低频部分高频进行重构 最后给出图像(Db5 can whine with the quality of the signal wavelet decomposition and reconstruction low-frequency part of the high-frequency image is given)

he value of tag could be set to any integer between 1 and 14 which correspods to the trial number of subject

基于连续hopfield网络的TSP问题解决方法(Based on continuous hopfield networks TSP problem solving)

杂波边缘 统一数据 五种方法,CA,GO,OS,GOSGO等 仿真图(Unified data clutter edge five methods, CA, GO, OS, GOSGO other simulation Figure)

it is matalb code for dipole antenna using fdtd