SPWM

SAR图像二维小波gabor变换，读取SAR图像，并进行Gabor变换，求得最大值和次最大值(Gabor two-dimensional wavelet transform for SAR image.read the SAR image, and the Gabor transform to obtain the maximum and times the maximum)

根据系统的输入和输出，辨识系统的的传递函数。该系统为6阶系统，通过降阶降为2阶后，加入状态反馈和状态观测器，调整参数使2阶系统稳定，最后用于控制原6阶系统。阶跃响应和bode图效果都不错。(Based on the input and output of the system, the transfer function of the system is identified. The system is a 6 order system. After the order is reduced to 2 order, the system is added with the state feedback and the state observer, which adjusts the parameters to make the 2 order system stable. Finally, it is used to control the original 6 order system. Step response and Bode figure results are good.)

optimum placement of DG

用matlab读取一个语音信号，对其进行变调，回音灯各种处理的设计报告，含代码与仿真图(Reads a speech signal with matlab, its tone, design reports echo lamp various treatments, including code and simulation map)

Applied numerical methods using MATLAB (Wiley,2005)

Simulink library block is created to achieve ADP learning methods for second order CT systems. This is based on Y. Jiang and Z. P. Jiang

AWGN信道和BSC信道的仿真程序，AWGN可调节信噪比，BSC可调节误码率(AWGN channel and the channel simulation program BSC, AWGN noise ratio can be adjusted, BSC bit error rate can be adjusted)

本程序旨在于解决用遗传算法解决多目标优化问题，同时加深对简单遗传算法的了解并进一步理解(The program aims to use genetic algorithm to solve multi-objective optimization problems, while deepening the understanding of the simple genetic algorithm and further understanding of)

基于cordic算法的nco仿真完整matlab程序(nco cordic algorithm simulation)

说明：  此程序是利用遗传算法在经济约束下计算潮流(This program uses genetic algorithms to calculate power flow under economic constraints)