15

标准接口1-5V转换成4-20mA程序，应用于标准传感器接入(Standard Interface 1-5V Converting 4-20mA Program for Standard Sensor Access)

network and other tehnologies. lan arhitecture

EtherNet/IP Socket Interface(This publication describes the socket interface that you can use to program MSG instructions to communicate between a Logix5000 controller via an EtherNet/IP module and Ethernet devices that do not support the EtherNet/IP application protocol, such as bar code scanners,RFID readers,or other standard Ethernet devices.)

this is the program for finding peak power in ofdm using pts

HC6800EM3 v20原理图（电路图）(HC6800EM3 V20 schematic diagram (circuit diagram))

用C++实现BPSK的仿真，包括信源，调制，信道，解调，计算误比特率(Using C++ implementation BPSK simulation, including source, modulation, channel, demodulator, bit error rate calculation)

the pdf entitled The Modulo Lattice Channel The Key Feature in Precoding is attached

说明：  wireless communication channels model

研究考虑多普勒频移fd情况的LFM调频目标回波特性(Study considers the case of Doppler shift fd target echo characteristics LFM FM)

该工程实现对单载波系统QPSK的频偏估计算法。调相信号在接收机相干解调时需要同频同相的参考载波，而发射机和接收机之间往往存在频率偏差，为了消除这种误差，必须在软件层面实现。使用了QPSK四相调制的信号特点进行载波频偏估计，经验证，效果较好。(This project implements frequency offset estimation algorithm for single carrier system QPSK. The phase modulation signal needs the same frequency reference carrier in the coherent demodulation of the receiver, and the frequency deviation often exists between the transmitter and the receiver. In order to eliminate this error, it must be implemented on the software level. The carrier frequency offset estimation is carried out by using the signal characteristics of QPSK four phase modulation.)