登录
首页 » matlab » 该工程实现对单载波系统QPSK的频偏估计算法 freq_estimate

该工程实现对单载波系统QPSK的频偏估计算法 freq_estimate

于 2020-06-27 发布 文件大小:2KB
0 605
下载积分: 1 下载次数: 41

代码说明:

  该工程实现对单载波系统QPSK的频偏估计算法。调相信号在接收机相干解调时需要同频同相的参考载波,而发射机和接收机之间往往存在频率偏差,为了消除这种误差,必须在软件层面实现。使用了QPSK四相调制的信号特点进行载波频偏估计,经验证,效果较好。(This project implements frequency offset estimation algorithm for single carrier system QPSK. The phase modulation signal needs the same frequency reference carrier in the coherent demodulation of the receiver, and the frequency deviation often exists between the transmitter and the receiver. In order to eliminate this error, it must be implemented on the software level. The carrier frequency offset estimation is carried out by using the signal characteristics of QPSK four phase modulation.)

文件列表:

freq_estimate\add_user_channel.m, 284 , 2016-07-28
freq_estimate\insert_pilot.m, 244 , 2016-07-28
freq_estimate\mod_qpsk.m, 339 , 2016-07-28
freq_estimate\QPSK.m, 1593 , 2018-04-12
freq_estimate\rx_freq_sync.m, 426 , 2016-07-28
freq_estimate\rx_phase_sync.m, 266 , 2016-07-28
freq_estimate\rx_phase_track.m, 361 , 2016-07-28
freq_estimate\test.m, 160 , 2016-07-28
freq_estimate, 0 , 2018-04-12

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • changesampleofpcmfile
    PCM文件采样率转换,其中可以自己定义采样率。作为WAV文件进行存储。效果较好。注意使用时确定源文件采样率。(PCM file sample rate conversion, which could define their own sampling rate. As a WAV file is stored. Effective. Note that when used to determine the source file sample rate.)
    2020-11-04 19:59:52下载
    积分:1
  • 05441004
    Multiple input multiple output techniques combined with orthogonal frequency division multiplexing (MIMO-OFDM) provide a promising approach for wireless systems. However, a serious drawback of the OFDM system is the high peak-toaverage power ratio (PAPR), which may severely affect the power efficiency of RF power amplifiers. In this paper, we propose a simple method to reduce the PAPR of MIMO-OFDM signals based on the use of unused subcarriers. Instead of processing the signals at each transmitter separately, a peak cancelling signal is generated at one antenna and is then applied to all the others with only simple modifications. Simulation has shown that a minimum 2 dB reduction in PAPR can be achieved for all transmit signals using this approach. As the signal processing is nearly all done at a single transmitter, repetition of the operations at each transmitter is avoided, and therefore the overall cost of the system can be significantly reduced.
    2011-11-05 01:46:42下载
    积分:1
  • Adaptive-Decision-Directed-Quantized-State-Algori
    addaptive decision directed quantize algorithm
    2012-06-08 02:19:03下载
    积分:1
  • passive-radar
    无源探测定位方法研究很好的学习无源被动雷达 很高兴和大家交流(Good learning passive probe positioning method Passive radar is very happy and the exchange of)
    2013-03-18 18:54:25下载
    积分:1
  • B1C信号的调制
    说明:  BOC调制的Matlab程序仿真及Simulink模型(Matlab program and BOC modulation simulation model of Simulink)
    2021-04-17 19:18:52下载
    积分:1
  • CMA_64QAM
    64QAM using CMA algorithm
    2020-10-17 19:37:27下载
    积分:1
  • sample2
    its a matlab code for the orthoganal
    2013-10-20 14:56:50下载
    积分:1
  • project
    信号估计 最大似然估计模块 克拉美罗界模块(Maximum likelihood estimation modules)
    2020-11-29 23:09:28下载
    积分:1
  • SISO
    siso信道模型,用于建立基础的点对点信道(SISO channel Model)
    2012-04-08 11:33:22下载
    积分:1
  • JAVAshouji
    说明:  这是手机的射击游戏,有一定的参考价值,可编译(shooting games, a certain reference value, compiler)
    2006-04-29 13:30:44下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载