Snake

关于MATLAB的编程和应用，及其在去除噪声中的应用，源程序的编写和修改(On MATLAB programming and applications, and its application in noise removal applications, the preparation and revision of the source code)

两个传感器进行串联形式连接，融合系统贝叶斯风险曲线以及ROC曲线(Two sensors are connected in series, as well as fusion system Bayesian risk curve ROC curve)

objectarx 自定义实体例子 objectarx 自定义实体例子 objectarx 自定义实体例子(objectarx acdbentity test objectarx acdbentity test objectarx acdbentity test)

基于yule_walker方程的空间谱估计算法，对学习空间谱估计与天线阵列的朋友会有帮助：）(yule_walker equation based on the spatial spectrum estimation algorithm right learning space spectrum estimation antenna array and friends will be helpful :))

矩形序贯，是传统序贯法的一种变异，可以处理一些特殊的多普勒回波(Rectangular sequential, is a variation of the traditional sequential method that can handle some special Doppler echo)

强混沌干扰中的谐波信号提取算法，对XiangKJMethod进行了改进(Strong chaotic interference harmonic signal extraction algorithm has been improved for XiangKJMethod)

This is a code for Uniform Linear Array Data

说明：  行向量绘图，在matlab中对于含有大量的数据，单独在一张静态的图上是显示效果是很不理想的，这个程序实现了在matlab中以示波器的形式动态的显示器波形图(Row vector graphics in matlab in containing a large amount of data, alone in a static chart is to show the effect is not ideal, the realization of this procedure in matlab in the form of oscilloscope waveform display dynamic)

使用matlab的simulink工具 仿真LTE中的Turbo编码器(Simulating the Turbo_encoder in LTE via the simulator of matlab )

本程序是矩形波的产生。第零步定义了要产生的波形的所有特征参数，矩形波的持续时间WIDTH，矩形波的采样点数POINTS,载波频率为F0，这个频率的最终引入是便于使用RF频率发射波形。第一步包括产生矩形波，并将其调制到RF上，注意，产生的信号的持续时间是矩形波宽度的5倍，这样，总的采样点数就是5*POINTS。同时还应注意，如果要产生一个基带信号，必须设置T0=0.第二步是画出所产生矩形波的源代码。( This procedure is rectangle wave production. Step to produce stage defined the waveform of all characteristic parameters, the duration of the rectangle wave WIDTH, rectangle wave sampling POINTS POINTS, carrier frequency F0, this frequency for the ultimate introduction is easy to use RF frequency emission waveforms. The first step including generating rectangle wave, and modulated to RF, attention, produce the duration of the signal is five times the width of rectangle wave, so, overall sampling POINTS is 5* POINTS. Also, note that if you want to produce a baseband signals must set T0 = 0. The second step is to draw a rectangular wave generated by the source code. )