Auto_Calib

说明：  求正弦信号和余弦信号的傅里叶变化，以及图形之间的转变(Sine signals and cosine signals request the Fourier transform, and the graphics change between)

说明：  file of paper abput image prossing

本程序是矩形波的产生。第零步定义了要产生的波形的所有特征参数，矩形波的持续时间WIDTH，矩形波的采样点数POINTS,载波频率为F0，这个频率的最终引入是便于使用RF频率发射波形。第一步包括产生矩形波，并将其调制到RF上，注意，产生的信号的持续时间是矩形波宽度的5倍，这样，总的采样点数就是5*POINTS。同时还应注意，如果要产生一个基带信号，必须设置T0=0.第二步是画出所产生矩形波的源代码。( This procedure is rectangle wave production. Step to produce stage defined the waveform of all characteristic parameters, the duration of the rectangle wave WIDTH, rectangle wave sampling POINTS POINTS, carrier frequency F0, this frequency for the ultimate introduction is easy to use RF frequency emission waveforms. The first step including generating rectangle wave, and modulated to RF, attention, produce the duration of the signal is five times the width of rectangle wave, so, overall sampling POINTS is 5* POINTS. Also, note that if you want to produce a baseband signals must set T0 = 0. The second step is to draw a rectangular wave generated by the source code. )

说明：  采用贝叶斯正则化算法提高bp网络的性能，即L-M优化算法(The use of Bayesian regularization algorithm to improve network performance bp, that is, LM optimization algorithm)

matlab ieee modified 30 bus data and pso economic disaptch

一本C语言的入门级实例教程，里面有很多例子，很实用(a book for flesh)

基于异步电动机的矢量控制模块，应用于中压船舶电力推进系统，可实现6KV船舶电网推进系统的矢量控制功能(VC contrl)

Fuel cells 燃料电池 用以研究 分散型电源并接(Fuel cells)

这本书是关于弹簧系统的，里面附有大量matlab程序，希望能看看(it is about the spring systyem)

MATLAB智能算法30个案例分析_源代码(30 case studies of the MATLAB intelligent algorithm source code,)