pid

EEPROM, 24LC256, .C, .H, Proteus, mplab, codigo-ascii

STM32开发板程序，包括底层文件固件库。为跑马灯功能。(STM32 development board procedures, including the underlying file firmware library. Function for the Marquee.)

交流电子负载，采用背靠背双PWM形式，实现能量的馈网，负载测采用三个单相逆变器来模拟。(PEL use PWM Simulator，can realise the power feed network)

利用单片机实现快速傅里叶变换 基于单片机对数据的采集(Fast Fourier transform using MCU Microcontroller based data acquisition)

此程序可实现长度为8位，周期为255的m序列，此序列可当做伪随机信号发生器，模拟信道噪声。(This procedure can achieve the length of 8 bits, the m sequence of 255 cycles, the sequence can be used as a pseudorandom signal generator, analog channel noise.)

基于STC12C5A60S2完整的光立方工程，有贪吃蛇、星光闪烁等效果(8*8*8 LED cube,snake,stars...)

说明：  用MSP430F149做的一个示波器，用Timer A定时触发AD转换，串口发送给电脑，最高采样频率100ksps左右，LABVIEW的visa接受和显示波形并可以控制时间轴和波形放大轴。(oscilloscope with MSP430F149 , starting with Timer A to trigger AD converter, send to the computer with RS232, the maximum sampling frequency 100ksps around, LABVIEW visa accept the data and display waveform and control the timeline and waveform magnification axis.)

开发环境是IAR, 是作用于MSP430F449的一个实验程序通过口线模拟IIC总线操作EEPROM，实验中在EEPROM的地址0x02写数据0x06，然后显示到LED[0],读出的数据显示到LED[1](Development environment is IAR, is the role of an experimental procedure on the MSP430F449 through the oral-wire analog IIC bus operation EEPROM, the experiment in the EEPROM address 0x02 write data 0x06, and then display to the LED [0], read out data to the LED [1 ])

数字电压计测电压频率。2015年电赛，精度高，易实现(The digital voltage measures the voltage frequency. 2015 electric competition, high precision, easy to achieve)

用一片DS1624完成本地数字温度的测量，并通过8位数码管显示出测量的温度值(暂无)