F340_motor

pid温控c程序算法，这是一个比较典型的PID处理程序，在使用单片机作为控制cpu时，请稍作简化，具体的PID参数必须由具体对象通过实验确定。由于单片机的处理速度和ram资源的限制，一般不采用浮点数运算，而将所有参数全部用整数，(pid temperature control algorithm c program)

说明：  stm32 串行flash 挂fatfs(fatfs for stm32 and spi flash)

这是关于单片机各种应用接口的子程序还有驱动程序，还是用c语言写的，非常实用(on SCM applications Interface subroutine also driver, or a c languages, very practical!)

说明：  模数转换芯片ads1100 读写程序 已应用于产品，可以直接使用(Analog-digital conversion chip to read and write ads1100 procedures have been applied to products, direct access to)

SABER是电源仿真的专业软件，此书为入门资源(SABER is a professional power supply simulation software, this book is Getting Started Resources)

51单片机与NFR24L01连接原理图，基于完整的ASM程序代码。双方都要采用项目的电路。(51 and NFR24L01 connection diagram, based on the complete ASM code. The two sides should adopt circuit project.)

用proteus仿真实现BLDC无刷直流电机的控制，目前仅工作于开环状态，可以参考一下。(BLDC brushless DC motor control is realized by Proteus simulation. At present, BLDC brushless DC motor only works in open-loop state, which can be referred to.)

这个事利用超声波模块测距然后通过串口发送到电脑的一个程序，适合上手学习超生波的同学(This use of ultrasonic module ranging through a serial port and then sent to a computer program, suit to students learning super living wave)

使用MSP430G2553芯片的定时器进行中断计时的四位数码管显示分钟和秒钟时间(Use MSP430G2553 chip timer interrupt timing four digital display minutes and seconds)

NRF2401-2.4G的无线通讯程序，51单片机完成(NRF2401-2.4G wireless communication procedures 51 MCU to complete)