登录
首页 » matlab » simpificationandreconstruction

simpificationandreconstruction

于 2009-11-16 发布 文件大小:56KB
0 192
下载积分: 1 下载次数: 24

代码说明:

  初步学习采样和重建信号。包括源程序和报告书。(Preliminary study of sampling and reconstruction of the signal. Including the source and report.)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • pingpufenxi
    声音的频谱分析 读取文件,分析频谱,画图(Read the file of the sound spectrum analysis, analysis of the spectrum, drawing)
    2012-09-03 20:56:06下载
    积分:1
  • BP-The-neural-network
    人工神经网络 matlab ,一个不错的学习机器,希望对大家有帮助了(Matlab artificial neural network, a good learning machine, hope to be helpful )
    2013-10-05 18:02:43下载
    积分:1
  • matlab
    说明:  用matlab进行通信过程中基带信号通过系统传输的模拟(describe a signal in fundamental frequency band transmit through a system with the matlab language)
    2009-07-31 10:08:08下载
    积分:1
  • tsls
    Two-Stage Least Squares method for instrumental variables estimation
    2011-05-13 08:06:14下载
    积分:1
  • ROI_extract
    Program will calculate the region of interest with free hand sketch and the selected will be shown
    2014-01-31 22:44:16下载
    积分:1
  • zishiyin
    线形阵列天线的自适应波束形成SMI SLC LMS 圆环形阵列的三维方向图(Adaptive beam forming a three-dimensional linear array antenna pattern SMI SLC LMS annular array)
    2014-02-18 18:28:18下载
    积分:1
  • POD
    POD (proper orthogonal decomposition) code in Matlab
    2007-12-12 10:22:38下载
    积分:1
  • DSP
    任务: 1) 借助MATLAB画出误差性能曲面和误差性能曲面的等值曲线(参考PPT2.1第17页的两幅图); 2) 写出最陡下降法以及LMS算法的计算公式(取 ); 3) 用MATLAB产生方差为0.05, 均值为0白噪音S(n),并画出某次采样得到的波形(即产生任意一个噪声随机序列); 4) 根据 2)中的公式,并利用 3)中产生的S(n),在 1)中的误差性能曲面的等值曲线上叠加画出采用最陡下降法以及LMS法时H(n)的在叠代过程中的轨迹曲线(参考PPT2.1第17页的右下图的曲线1和曲线2)。 5)用MATLAB计算并画出LMS法时 随时间n的变化曲线(对应S(n)的某一次的一次实现)和e(n)波形; 注意:某一次实现的结果并不能从统计的角度反映实验的结果 的正确性,为得到具有统计特性的实验结果,可用足够多次的 实验结果的平均值作为实验的结果。用MATLAB计算并画出 采用LMS法时,J(n)的100次实验结果的平均值随时间n的变 化曲线(即 生成随机噪声信号并计算结果,重复执行100次, 求平均结果)。 6)在 1)中的误差性能曲面的等值曲线上,叠加画出采用LMS法得到的100次实验中的H(n)的平均值的轨迹曲线; (Task: 1 ) Draw with MATLAB error performance surface and surface contour error performance curve ( refer PPT2.1 two chart on page 17 ) 2 ) Write the steepest descent method and the LMS algorithm formula ( take ) 3 ) Using MATLAB to generate variance of 0.05 with a mean of 0 white noise S (n), and draw a particular sampling waveform ( ie, any noise generated random sequence ) 4 ) based on 2 ) of the formula , and use 3 ) generated in S (n), in a ) the error performance curves superimposed on the surface contour plot using the steepest descent method and the LMS method when H (n) the iterative process in the trajectory curve ( refer PPT2.1 page 17 bottom right of the curves 1 and 2 ) . 5 ) using MATLAB LMS method is used calculate and draw the curve with time n (corresponding to S (n) of a first implementation of a ) and e (n) waveform Note : in a first implementation of the results are not reflected from a statistical point of view of accuracy of the experimental results ,)
    2013-11-08 20:09:06下载
    积分:1
  • mat_disperse_groupvelocity
    This Program is used for calculating surface wave group velocity(This Program is used for calculating surfa ce wave group velocity)
    2007-01-31 15:09:02下载
    积分:1
  • NonLinear_original-2-minus0.1
    ABAQUS UMAT 带剪切非线性HASHIN准则(ABAQUS UMAT)
    2015-10-16 16:42:12下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载