-
电容表89c52,比较精确,可以自己制作,内带pcb图
电容表89c52,比较精确,可以自己制作,内带pcb图-Capacitance Table 89c52, more precise, you can produce their own, which with pcb diagram
- 2022-03-24 00:16:00下载
- 积分:1
-
直流电机控制程序,看大家,做下评论,
控制直流电机的c程序,大家看一下,做下点评,-C DC motor control procedures, look at everybody, to do under the comments,
- 2022-06-17 17:31:16下载
- 积分:1
-
本程序是AVR系列单片机的外部中断程序,中断实验,LED数码管显示中断数据,按键按下计数,数码管显示计数结果...
本程序是AVR系列单片机的外部中断程序,中断实验,LED数码管显示中断数据,按键按下计数,数码管显示计数结果-This procedure is the AVR MCU external interrupt procedures, interruption of the experiment, LED digital tube display interruption data, press the count button, digital display count results
- 2022-01-26 14:08:23下载
- 积分:1
-
串口通讯的上位机软件,希望你能用的上,是用V++写的,
串口通讯的上位机软件,希望你能用的上,是用V++写的,-The host computer serial communication software, I hope you can use the upper, is written in V++, thank you
- 2023-04-24 11:40:03下载
- 积分:1
-
lpc764AD
lpc764AD的例子-lpc764AD
- 2022-03-01 12:14:53下载
- 积分:1
-
GPL162001 the I2C functionality demo program
GPL162001 I2C功能演示程序
- 2023-03-17 02:20:04下载
- 积分:1
-
用C51开发的单片机多机通讯程序,其中包括双口RAM的读写程序。
这个程序调试通过,应用在我开发的系统中,效果很好。...
用C51开发的单片机多机通讯程序,其中包括双口RAM的读写程序。
这个程序调试通过,应用在我开发的系统中,效果很好。-C51 Microcontroller with the development of multi-machine communication procedures, including dual-port RAM reading and writing process. Debugging through this process, the application in my development system, good results.
- 2022-11-07 15:45:02下载
- 积分:1
-
本电路主要显示两种液晶显示模块并详细介绍JHD162AJ及FYD12864与51单片机的接口及相应的应用程序....
本电路主要显示两种液晶显示模块并详细介绍JHD162AJ及FYD12864与51单片机的接口及相应的应用程序.-This circuit shows the two major liquid crystal display module and a detailed introduction JHD162AJ and FYD12864 MCU with 51 and the corresponding applications.
- 2022-03-26 16:47:57下载
- 积分:1
-
《单片机语言C51程序设计》的部分配套源代码,适合于刚开始接触单片机编程的程序员...
《单片机语言C51程序设计》的部分配套源代码,适合于刚开始接触单片机编程的程序员- Single-chip C51 programming language part of supporting source code, suitable for beginning programmers contacts Microcontroller Programmer
- 2022-05-14 19:25:56下载
- 积分:1
-
利用动态扫描和定时器1在数码管上显示
出从765432开始以1/10秒的速度往下递减
直至765398并保持显示此数,与此同时利
用定时器0以500...
利用动态扫描和定时器1在数码管上显示
出从765432开始以1/10秒的速度往下递减
直至765398并保持显示此数,与此同时利
用定时器0以500MS速度进行流水灯从上至
下移动,当数码管上数减到停止时,实验
板上流水灯也停止然后全部开始闪烁,3秒
后(用T0定时)流水灯全部关闭、数码管上
显示出"HELLO"。到此保持住。
设晶振频率为12MHz。-The use of dynamic scanning and Timer 1 in the digital control to show from the beginning of 765,432 to 1/10 seconds until the speed of descending down 765,398 and maintain display this number, at the same time the use of Timer 0 to 500ms the speed of light from the flowing water to Under the move, when reduced to a few digital tube stop, the experiment on-board water stop and then all the lights started to flicker, 3 seconds later (T0 regularly used) closed water lights, digital tubes show
- 2022-02-03 00:14:56下载
- 积分:1