英飞凌16位单片机XC164CS的TWINCAN应用资料，很详细，非常好用

AVR Programme is a SPI Example

占空比可调信号发生器，单片机原理程序代码，已成功运行。-Adjustable duty cycle signal generator, the principle of single-chip code has been run successfully.

< 单片机网络教程>>，包含上，中两部分，是单片机初学者很好的参考书。希望对大家有些帮助。

基于H83664的空调控制模拟系统 aircondition.c、intprg.c -based on the simulation of air-conditioning control system aircondition.c. intprg.c

本程序为RF收发程序，采用外部中断判断脉冲长度，通过遥控接收程序。-This procedure for the RF transceiver procedures, using external interrupt pulse to determine the length of the procedure by remote control receiver.

HT1622驱动程序，可以用于驱动液晶显示-HT1622 driver, can be used to drive liquid crystal display

i2c通讯C程序源代码,经测试合格,可以放心使用,请注意时钟周期-i2c communication C program source code, have been tested and qualified, you can rest assured that the use of, please note that clock cycle

视觉暂留，编程从一个I/O口输出一扫频信号，驱动一支LED灯闪动，频率范围为10HZ~99HZ，扫描时间为30秒，在LED闪动期间观察，一旦发现无法识别LED灯闪动时，按下按键K1，立即停止输出，并将此时的信号频率显示在数码管上，该信号的周期为测试者的视觉暂留时间。-Persistence of vision, programming from an I/O port outputs a sweep signal to drive an LED light flashing, the frequency range of 10HZ ~ 99HZ, scan time of 30 seconds, the LED flashing during the observation, once found it impossible to identify the LED lights flashing, press the key K1, immediate cessation of the output, and at this time the signal frequency displayed on the digital control on the test cycle of the signal" s persistence of vision time.

18b01驱动采用单片机显示18b20温度驱动

ST7787 驱动程序，比亚迪2.4inch的LCM驱动程序，初始化代码-ST7787 driver, the LCM BYD 2.4inch driver initialization code