这是一个使用M128芯片的多功能仪器，使用了16位的定时器，2路的UART。开发工具为 GCC3.2，PC上机位程序使用VB6开发...

16位计数及激光测距仪的源程序,C源代码,对学习有很好的参考价值.-16 counts and laser rangefinders of the source, C source code, to learn a good reference value.

用于MAX187的12位AD 转换程序,附带1602液晶驱动函数-For MAX187 12-bit AD conversion process, with 1602 LCD driver function

PIC单片机PICC环境下PIC18FXX20系列通用头文件-PIC Singlechip PICC environment PIC18FXX20 Series Universal header files

1302实现时钟定时报警，并在1602液晶体显示-1302 realize alarm clock timer and LCD display in 1602

LT-1B msp430开发板例子程序－ADC12_09

使用键盘上的上、下、左、右四个按键，可以分别控制led1,2,3,4, 每个LED 对应的Port 请参考“实验平台介绍”说明文档。要求按下 上面提到的四个按键中间的一个按键后，该按键对应的led 被点亮，持续1 秒钟以后led 熄 灭。-Use the keyboard on the upper and lower, left, and right buttons, can control led1, 2,3,4, each LED corresponding to the Port, please refer to " experiment on" documentation. Requirements of the four above-mentioned press the middle button of a button, the button that corresponds to being light led, continuous 1 second later led out.

c8051f020的128×64图形液晶显示图形的程序，图形液晶的型号为lm3033a-C8051f020 128 64 graphics LCD graphical procedures, graphic LCD models for lm3033a

用C51编写的74HC595驱动数码管通用程序，可显示浮点数-C51 prepared using 74HC595 driver generic digital tube procedures, can display floating-point numbers

基于51单片机的液晶12864图片驱动及串行收发程序-Based on 51 single-chip LCD driver and serial 12864 picture transceiver procedures

Base64编码方法及例程，其功能和方法都在文件的开头部分说明。-Base64 encoding methods and routines, its functions and methods at the beginning of the document part.