锯齿波信号发生器 函数信号源采用数字存储方式存储一到几个周期，再用时间计数，循环执行的方法实现函数信号的连续输出...

将单片机的IOA0~IOA7分别接按键S1~S8连接到高电平上。此时，如果某个按键被按下，对应的I/O端口就会输入高电平进单片机，即按键S3按下，IOA2会输入高电平进单片机-Will Singlechip IOA0 ~ IOA7 access keys, respectively, S1 ~ S8 is connected to high on. At this point, if a button is pressed, the corresponding I/O port will enter into the high single-chip, that is, S3 button press, IOA2 will enter into single-chip high

MSP430有许多寄存器来设定程序的频率和周期，本文总结如定时器A,看门狗，模拟比较器等的代码，供大家参考学习.-MSP430 has a number of registers to set the procedures for the frequency and cycle, such as This paper summarizes the timer A, watchdog, analog comparator, such as the code for your learning.

单片微机原理及应用,MCS-51硬件结构-Single-chip Microcomputer Principle and Application, MCS-51 hardware structure

通过GPRS的PPP拔号程序,本程序在x86下通过测试-through GPRS PPP dialup procedures, the procedures adopted in x86 tests

德国KVASER公司关于MCP2510驱动的源代码-Germany KVASER company on the MCP2510-driven source code

一个电表的程序，能够直接使用，该芯片使用的是7169，请大家参阅-a meter procedures can directly use, the chip is used in 7169, please refer to

Eeprom操作, 可对EEPROM进行相应的读写等操作-eeprom operation

交流采样的滤波资料和一些参考程序，对于做测控系统的有一定的参考意义-AC sampling filter information and some reference procedures for monitoring and control systems do have some reference value

一个可调小时分钟的数字钟系统，先是在液晶屏上，显示开始为00：00：

usb-串 口 转 换pcb板 图,pcb格式-usb-serial conversion pcb map, pcb format