Communications through COM1 and MCU interface process contains three threads

异步电机无速度传感器直接功率控制系统,很好的资料-Induction motor speed sensorless direct power control systems, good information

Elan eKTP8733N单片机开发程序，用于驱动PWM接口。在Elan 公司开发环境中使用。-Elan eKTP8733N single-chip development process, used to drive PWM interface. Elan has developed in the environment.

DS18B20 c51程序（EE21学习板演示程序） -DS18B20 c51 procedures (EE21 learning demo board)

实现AD转换tlc549芯片的驱动，建模力量转化为数字量-TLC549 chip AD conversion realize the driving, modeling forces into digital

IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta

单片机Com端口仿真，有程序及仿真原理图-Com-port single-chip simulation, there are procedures and simulation schematic

按摩椅软件开发示例,VB-PIC单片机通讯题,主要是串口通讯问题-massage chairs software development practices, VB- PIC communications problems, the main problem is the serial communication

一个简单实用的单片机键盘扫描程序。键盘为4*4扫描的键盘，通过行列扫描进行键码判断，并通过串行口或者485信号输出键码。应用于银行系统。-A simple and practical single-chip microcomputer keyboard scanner. 4* 4 keyboard for keyboard scanning, scan through the ranks to determine the key code and, through the serial port or a key code signal output 485. Applies to the banking system.

ZLG/GUI HD61202或KS0108驱动

诺基亚FBU