MSP430单片机C语言应用程序设计实例精讲,单片机开发的朋友可以作为参考...

51单片机操作89F0X0系列FLASH存储器的程序-51 89F0X0 Series MCU operating procedures FLASH memory

Eeprom操作, 可对EEPROM进行相应的读写等操作-eeprom operation

常用串行EEPROM的编程应用，Microwire总线是美国国家半导体公司研发的一种简单的串行通讯接口协议，该总线是采用三线进行数据传输。Microwire总线和SPI总线一样数据输入输出分别使用一根引线，同样可以提供同步数据传输方式，可以适用在多种微控制器、EEPROM或ADC等场合。-Commonly used application of serial EEPROM programming, Microwire bus is the United States National Semiconductor R

万年历 megal128 iccavr开发平台-Calendar megal128 iccavr development platform

利用测量频率的方法进行运算 测量速度和里程，并用LED显示-The use of methods of measuring the frequency of computing the speed and length measurement, and LED display

利用8051完成读写紧凑型闪存卡文件系统的实现

热电偶的冷端补偿和线性化.pdf 网上搜下来的，-Thermocouple cold junction compensation and linearization. Pdf

1．熟悉硬件仿真工具KD30的使用。 2．修改样本程序 SAMP1a，使无论在计数或停止计数时，按 SW3 均对计数值清零，并停止计数。 3．编制一个秒表程序, 测试精度为0.1秒，按 SW1键启动计数，再按一次 SW1键停止计数。任何时候按 SW3 键停止计数，并对计数值清零。 4．按 SW1键后， 以 0.1 秒为单位开始计数，再按一次 SW1 键停止计数。若按 SW1 键时间超过2秒，则计数值清零，回到初始状态。-1. Familiar with the hardware simulation tool KD30 use. 2. Revised procedures SAMP1a samples, regardless of the count or counts at the end, according to SW3 numerical terms were right, reset, and stop counting. 3. Preparation of a stopwatch procedures, testing accuracy of 0.1 seconds, according to bond SW1 start counting, according to a key SW1 stopped counting. By SW3 any time to stop counting bond and reset the count. 4. By SW1 bond, after 0.1 seconds for start counting, according to a key SW1 stopped counting. If SW1 keys by the time more than two seconds, then reset the count and return to the initial state.

单片机基础，经典,初学必备-microcontroller based, classic, beginner essential

高频头1256编程，可LCD显示频道好，此原码为8个频道解调，其他频道请类推！-Tuner 1256 programming, LCD display can be a good channel, the original code for the 8-channel demodulation, and so on other channels, please!