单

ARM采用的是LPC2210，液晶采用TFT的。源码为C。在SMATR2210上使用过。-ARM is based on LPC2210, the use of TFT LCD

编写一个延时1MS子程序根据题目选择是定时还是记数状态，本题选择记数状态。然后根据延时1MS计算出计时器的初值是E0H（高8位）18H（低5位）。最后编写算法，对T0初始化，利用T0的中断TF0调用中断处理程序。-prepared a delay rungs subroutine under the topic chosen is not a time to memorize numbers or state of mind of the few options that state. According to delay timer rungs calculate the initial value is E0H (high 8) 18H (Low 5). Preparation of the final algorithm, the T0 initialization, interrupt the use of T0 TF0 call interrupt handling procedures.

基于盛群ht46r232单片机的C语言 液晶显示屏1602a的显示驱动程序 -Based on SCM ht46r232 Holtek C language 1602a LCD display driver

详细的介绍了msp430单片机的c语言编程，有很多例子。-Detailed introduction of the MSP430 MCU c language programming, there are many examples.

　单片机实现非接触式IC卡读写 哟详细的原理图和代码！！！！！！！！！！！！！！！！！1-Singlechip realize non-contact IC card reader yo detailed schematics and code! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! 1

使用avr90can32双串口传输蓝牙数据-Avr90can32 dual-use Bluetooth serial data transmission

控制ADLTC1407转换器工作，实现模数转换功能-AD LTC1407

单片机实现直流数控稳压电源,可调电压为0-9.9伏,步进为0.1伏-NC regulators realize single-chip DC power supply, adjustable voltage of 0-9.9 V, step 0.1 V

在点阵式液晶显示器上显示字符-in dot-matrix liquid crystal display characters on the show

这是一个基于凌阳单片机SPCE061A的GPS定位仪c代码-This is a single-chip based on the Sunplus SPCE061A of GPS positioning c code