The touch screen driver reads input from touch screen hardware and converts it t...

周立功大侠编的一个学习arm嵌入式基础知识的好ppt,对初学者很有帮助-Week Ligong heroes made a study arm of a good basic knowledge of embedded ppt, very helpful for beginners

用Quartus II 设计的3级流水CPU，指令采用二次重叠执行方式-Quartus II design with three-stage pipeline CPU, instruction execution overlaps with the second time

c8051f340开发一款小游戏贪食蛇游戏，和我们小时候玩的游戏更清楚，用TFT彩屏，用游戏手柄玩的 

《新概念51单片机C语言教程:入门、提高、开发、拓展全攻略》书上例程代码

多周期处理器--verilog写的,欢迎大家来下载，-multicycle microprocessor written with verilog HDL

LPC21xxISP 烧写软件,欢迎使用!-LPC21xxISP programmer software, Welcome!

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

汇编编写的ARM启动代码，包括中断向量、运行域搬移、堆栈设置等代码的演示，还包括了一个scatter文件，注释详细。麻雀虽小五脏俱全，对于ARM编程的初学者，有助于理解ARM的代码链接和生成，以及启动过程。代码使用ADS1.2编写，可以直接运行查看。-Compilation prepared by ARM startup code, including the interrupt vector, run the domain move, stack setup code demonstration, but also a scatter file, comments in detail. Sparrows are small is a fully-equipped, for ARM programming for beginners, help to understand the link ARM code and generation, as well as the boot process. Code uses ADS1.2 prepared, you can directly run the Show.

本程序也是转载的，但具体网址忘了，只是分享一下，没有任何商业用途 程序主要是讲YUV422的格式图像转换成RGB888的，请大家多多指教

S3C44B0的样例程序！-S3C44B0 the sample program!