128* Embedded function (original)

基于讯通公司的nrf2401单片机进行的无限通信程序。-NRF2401 show based on the company

单片机数字音乐盒课程设计，内含源代码，报告说明详细，绝对可用（music.asm)-SCM digital music boxes curriculum design, containing the source code, the report describes in detail, absolutely available (music.asm)

RC500 MF1 非接触读卡器 开发板 资料-Demo board of philips rc500 chip hv Ev Kit of it and all datasheet

这是基于单片机的gprs编程 希望能给予大家帮助 -This is based on the MCU programming gprs hope to help everyone

AVR GCC编程参考手册，非常适合做开发参考-AVR GCC programming reference manual, is well suited to do the development of reference

５１单片机综合设计开发事例-51 Single-chip integrated design and development examples

avr单片机EEPROM读写程序 经过调试，已经成功进行读写-avr after single-chip EEPROM read and write debug procedures have been successfully read and write

老外写的基于arm的sd/mmc读写程序，开源的项目-foreigner was based arm of sd/-3.4 reading and writing procedures, open-source project

c语言编程的8位密码锁，用Protues进行仿真，效果不错-c language programming of eight locks with Protues simulation, good results

单片机P1口与4个按键连接，用于信号幅度和频率调节操作键。单片机P0、P2.7、P3.6(-WR)与DA0832、2个741(运放)连接构成波形信号输出电路。 编程使波形信号输出电路输出正弦波信号，并且可通过操作键调节信号的幅度和频率。幅度和频率调节级别从0~10，共11个等级。 -Singlechip P1 I connect with the four buttons for the signal amplitude and frequency adjustment operation keys. Singlechip P0, P2.7, P3.6 (-WR) and DA0832, 2 months 741 (operational amplifier) to connect constitute waveform signal output circuit. Programming so that waveform signal output circuit output sine wave signal, and can be operated keys adjust the signal amplitude and frequency. Amplitude and frequency adjustment level from 0 ~ 10, a total of 11 grades.