6017FM in Mountain View, audio initialization procedure, good results!

从串口读取数据，有两种方法， 1、每接收一个EV_RXCHAR,就用ReadFile读一次，这样我觉得太恐怖了。 2、接收到一个EV_RXCHAR后，等一定数据量的CPU周期(GetTickCount),再一次性读取缓冲区里的数据。这样做，一般情况下不会有问题，但是，如果数据很多，过了“一定数据量的CPU周期”，还没收完数据怎么办？就会少读数据了。 我用三个线程序来完成串口数据的-read data from the serial port, there are two methods, one, each receiving a EV_RXCHAR, on the ReadFile read, I think this vote. 2, received a EV_RXCHAR after a certain volume of data, such as CPU cycles (GetTickCount), and the one-time reader, the data buffer. To do so, under normal circumstances there is no problem, but if many of the data, and after a "certain amount of data the CPU cycles," also confiscated End Data how do? Few will read the data. I used three lines to complete serial data

这是一个GPS芯片的程序，能够读取各种GPS信号，采用串口通信，能够准确地定位地理信息-This is a GPS chip procedures, be able to read a variety of GPS signal, using serial communications, be able to accurately geo-positioning information

多线程，多接收模式串口类 LsComm ,串口通信源代码!-multi-threaded, multi-mode receiver category LsComm serial, serial communications source code!

moden串口编程（涉及AT指令，通用异步接收发器UART）-moden Serial Programming (involving AT command universal asynchronous receiver transmitters UART)

介绍了如何用verilog语言实现处理器部件uart-Describes how to use Verilog language processor components UART

Low Rate Wireless Personal Area Networks (LR-WPANs)in C-Low Rate Wireless Personal Area Networks ( LR-WPANs) in C.

语音de 椅子 好学习大-voice de studying the big chair

GPS数据采集程序 希望对各位有用-GPS data collection procedures hope useful to you!

利用MSComm控件，不依赖太多硬件设备，指利用纯软件方法侦测串口通信参数设置情况-use MSComm control, do not rely on too many hardware devices that use software-only method to detect serial communication parameters settings

本人所编的一个关于RS232传输的小程序，可以传送数据，请大家多指教啊-I have made a transmission on the RS232 applet, you can transmit data, please advise U.S. multi-ah