51 single blow interrupt reception procedures

此为串口编程的一个实例，利用VC实现了双机互联，各位不妨试一试！-this as a serial programming examples, the use of the VC-Internet machine, you may wish to try it!

51单片机的智能反汇编 code:5548823116-51 microcontroller smart anti-compilation code : 5548823116

这个是串口的基于停止等待协议原理编程，这个是接收程序，很好用哦-this is the agreement on principle to stop waiting for the program, this is the receiving process, oh well spent

一个Mega8 SPI读写DataFlash的代码,是用C语言编写的。可访问Atmel AT45Dxxx dataflash，支持512Kbit - 64Mbit。 -a Mega8 SPI DataFlash code reader, is to use the C language. Visit Atmel AT45Dxxx dataflash, support casing- 64Mbit.

用C++写的RS232串口异步通讯功能模块，支持16550 UART芯片，中断收发数据，波特率最大115200bps，自定义收发数据缓冲大小，支持软硬件流控。-C wrote asynchronous RS232 serial communication module, 16550 UART chip, Transceivers interruption data, 115,200 bps maximum baud rate, since the definition of sending and receiving data buffer size, support hardware and software flow control.

此程序利用串口读取民航AFTN电报网中的AFTN信息，然后进行电报解读，并将解读出来的信息存储到数据库中。是民航常用的电报数据读取端口-use of this procedure to read CAD AFTN serial cable network AFTN the information and then proceed telegram read, and read out the stored information to the database. CAD is used to read the data cable port

本程序是i2c总线读写一个字节的程序。在写过程序中，不一定非要检测i2c的应答位，可以直接延时过去就行，但是在读过程中必须给应答信号，读完发停止位，一定确认所发的信号都发上了。否则在连续地址读的过程中可能不会出错，但是在随机度过程中就会出错，我的程序就是在给停止信号时没有给上，24cxx一直在输出数据，结果读出错。找着问题后我的程序只加入了一条命令便完全正常。-i2c bus read and write a byte procedures. The written procedure, not necessarily require the detection i2c-response, and can directly past trip delay, but the process must be read to the response signal, stopped at reading, we recognize the signals are on the fat. Otherwise, the address read for the course could not go wrong, but the randomness of the process would be a mistake, I was in the process to stop for no signal, 24cxx in output data, read errors. I discovered the problem after the procedure just joined the order of a completely normal.

profibus主站及从站源代码，可以作为主从站开发的借鉴-Profibus master and slave source code can be used as a major development from the point of reference

本程序为串口调试软件很好的。可以传送TXT文件，和HEX文件，还可以自动发送。-procedures for the Serial debugging software very well. Can send TXT documents, and HEX files and also automatically send.

PL2303 driver , usb to serial driver for mobile phones