带字库液晶驱动.ST7920的读写 带字库液晶驱动.ST7920的读写

LT_1B msp430开发板例子程序－UART11_024-LT_1B msp430开发板例子程序－UART11_02400

使用LPT口，模拟IIC，界面友好，使用方便，不失为一个硬件调试的好帮手！ 亦可透过IIC实现双机互连，因为IIC支持主从模式:-)-LPT I used to simulate IIC, friendly interface and ease of use, hardware debugging is a good helper! Through dual-IIC interconnection, as IIC support from the main mode :-)

使用凌阳SPCE061A为主控核的测温程序，温度传感器为单总线温度传感器DS18B20，用液晶12864显示温度值，连接方式请按程序中所列方式连接，工程可直接下载使用。-Sunplus SPCE061A to master the use of core temperature measurement procedure, temperature sensor for the single-bus temperature sensor DS18B20, LCD 12864 display temperature values, connections requested in accordance with the procedure set out ways to connect, engineering direct download.

SMC162S实现时钟，可以计时，即实现数字时钟-Realize SMC162S clock, can be a time, that is, digital clock

MT8880单片机控制的测试程序-MT8880 SCM control testing procedures

用于手持时钟受时，时钟芯片的工作稳定性，以D18B20温度传感器的采集，微调时钟芯片的内置电容，改变震荡频率-For hand-held by the clock, the clock chip of job stability to temperature sensor D18B20 collection, fine-tuning of the built-in clock chip capacitors to change the vibration frequency

这篇程序是我一个同学编的,并且已经应用到了二相步进电机(四线步进电机)上了.但是我认为此程序需要改进的地方有很多. -This procedure is a fellow student, I made and have been applied to a two-phase stepper motor (four-wire stepper motor) on. But I think this process needs to be improved where there are many.

STC89C58RD +宏芯（driver）驱动TOPPTFT_LCD-STC89C58RD+ Macro-core (driver) driver TOPPTFT_LCD

角度传感器KMZ41+UZZ9001初始化和读写程序-Angle sensor KMZ41+ UZZ9001 initialization and read-write process

nRF24LO1_SPI程序，MCU控制两块nRF24LO1之间的无线通讯，也可以通过UART打印和发送数据-nRF24LO1_SPI procedures, MCU control nRF24LO1 between the two wireless communications, can also print and send data UART