基于WINBOND单片机W78E516B的最小系统源代码.通过UART具有BOOTLOAD功能.开发环境为KEIL C51....

DS1302显示时钟，通过液晶12232显示。-DS1302 display clock through the liquid crystal display 12232.

pid，用于飞思卡尔智能车比赛，学习资料-pid, for Freescale" s Smart car

16*2液晶显示1602驱动程序，内附与单片机的简单接口电路-16* 2 LCD 1602 driver attached with a simple single-chip interface circuit

这是原创的基于PIC16F877A单片机的读SD卡文件系统程序源代码-This is the original PIC16F877A microcontroller-based SD card file system read source code

单片机89c51对usb操作的全过程,初始化，读写-SCM 89c51 right usb operate the entire process, initialization, reading and writing

可用于任何单片机平台的I2C总线读写程序，IO脚模拟。-Single-chip platform can be used for any of the I2C bus to read and write procedures, IO pin analog.

MAX7219驱动例程，工程内还有DS1302等驱动代码，是学习写驱动不错的工程。-MAX7219-driven routines, engineering, etc. There are DS1302 driver code, is to learn to write good works driver.

1．熟悉硬件仿真工具KD30的使用。 2．修改样本程序 SAMP1a，使无论在计数或停止计数时，按 SW3 均对计数值清零，并停止计数。 3．编制一个秒表程序, 测试精度为0.1秒，按 SW1键启动计数，再按一次 SW1键停止计数。任何时候按 SW3 键停止计数，并对计数值清零。 4．按 SW1键后， 以 0.1 秒为单位开始计数，再按一次 SW1 键停止计数。若按 SW1 键时间超过2秒，则计数值清零，回到初始状态。-1. Familiar with the hardware simulation tool KD30 use. 2. Revised procedures SAMP1a samples, regardless of the count or counts at the end, according to SW3 numerical terms were right, reset, and stop counting. 3. Preparation of a stopwatch procedures, testing accuracy of 0.1 seconds, according to bond SW1 start counting, according to a key SW1 stopped counting. By SW3 any time to stop counting bond and reset the count. 4. By SW1 bond, after 0.1 seconds for start counting, according to a key SW1 stopped counting. If SW1 keys by the time more than two seconds, then reset the count and return to the initial state.

自己写的关于车台控制面板的演示程序，有兴趣，可以查看-Write their own control panel on the car of Taiwan demo program, are interested in, you can view

用51单片机控制硬盘读写，并用通过液晶界面显示。-SCM control with 51 hard drives to read and write, and use the LCD interface display.