此为18B20的温度检测以及键盘控制和液晶显示程序.好用.

本程序使用AduC812单片机,实现从键盘读取数字,并用LED指示灯显示按键所在行列数-the procedures used Aduc812 Microcontroller microcontroller, read from a digital keyboard and LED indicator shows where the ranks of a few buttons

用keil编译，单片机读硬盘，制作mp3，带lcd显示驱动。-Using keil compiler, microcontroller read the hard disk, create mp3, with lcd display driver.

该算法为带低通滤波的PID控制仿真源代码 用MATlab开发，能够管直接运行-The algorithm for the low-pass filtering with the PID control simulation using Matlab source code development, to pipe directly to run

对新的液晶进行扫描，检查是否有坏的点阵-The new LCD to scan, check whether there is a bad dot-matrix

将TIDSP 转换后的H文件 再利用此程序可生成 KIEL 的HEX.文件 加载到单片机里运行-TIDSP converted to H document re-use this program KIEL generates the HEX. File loaded into the single-chip microcomputer to run

功能： 1、作为主机通讯采集两路下位机数据并将此数据通过8255送出（十路水位值） 并计算水头送STC板 2、采集数据为BCD码制，先转换成二进制，处理后再转换成BCD 3、通讯采用方式3，多机通讯，上位机发地址时TB8=1，其他TB8=0 下位机SM2=1，RB8=1时产生中断后使SM2=0收发数据，结束后SM2=1 在此系统中本机硬件地址要设为0-Features: 1, as the host of two-way communication acquisition of data-bit machine and send this data through 8255 (the road level 10 value) and calculate the head sent to STC board 2, for BCD code data collection system, the first converted into binary, and then deal with the conversion into BCD 3, communication using methods 3, multi-machine communications, address PC made TB8 = 1, other TB8 = 0 under the digital machine SM2 = 1, RB8 = 1 when the failure to make SM2 = 0 to send and receive data, after the end of SM2 = 1 in this system to the local hardware address set to 0

12864LCD液晶仿真，控制器为[ks0108] 07液晶12864显示菜单[ks0108]-LCD 12864LCD simulation, controller [ks0108] 07 LCD 12864 display menu [ks0108]

78K0S EEPROM模拟功能程序，C语言，可直接调用-Analog functions 78K0S EEPROM process, C language, can be directly called

4*4扫描键盘,通过键值通过4个数码管显示出来.-4* 4 Scanning keyboard, through key through four digital tube display.

红外线遥控的相关代码及主控芯片的参考资料-Infrared remote control code and master the relevant reference chip