LT_1B msp430开发板例子程序－UART_U192

keyboard TI TMPS430单片机使用例子，希望对象我一样的初学者有帮助-keyboard use TI TMPS430 SCM example, I hope that the same object is to help beginners

TCPIP在ADI公司ADU812处理器上的移植-ADI ADU812 processors transplant

Msp430的flash读写文件配置文件，(msp430f427芯片)-MSP430

IAR例子，里面是一个完整的四位LCD液晶显示例子。-IAR examples, which is a complete example of the four LCD liquid crystal display.

MCS-51单片机有5个中断源，其中两个是由-INT0、-INT1引脚输入的外部中断源；另外三个是内部中断源即由T0、T1的溢出引起中断和串行口发送完一个字节或接收到一个字节数据引起中断。触发外部中断有两种方式，即下降沿引起中断或低电平引起中断。当编程TCON中的ITi（i=0、1）为1时，则引起触发的方式为边沿触发方式，反之(ITi=0)为低电平触发方式。每个中断源的中断请求能否得到响应要受两级“开关”的控制，即一个总“开关”-MCS-51 single-chip has five interrupt sources, two of which are by-INT0,-INT1 pin input external interrupt source the other three internal interrupt sources from the T0, T1 overflow caused by the disruption and serial port sending or receiving end of a byte to a byte of data caused by interruption. Triggered external interrupt has two modes, namely, falling edge or low-level disruption caused disruption caused. When programming TCON in ITi (i = 0,1) for the 1:00 has been the subject of a way to trigger the way to the edge of the trigger, on the contrary (ITi = 0) for low-level trigger mode. Each interrupt source interrupt request can be subject to levels in response to

通过直接读取磁盘扇区的测试程序，开发单片机读卡器的U程序员可以了解FAT16文件系统。

实现stc12c5410ad/stc12c2051单片机ad转换和pwm功能-Single-chip implementation stc12c5410ad/stc12c2051 function ad conversion and pwm

液晶显示器与单片机接口电路程序，实现液晶显示对于信号源发生信号的控制和显示-LCD and microcontroller interface circuit procedures, LCD occurred signal source for the control signal and display

arm7 bootloader source, very good-arm7 Bootloader source, very good

pic16f上12864液晶显示，ad转换程序，时钟显示程序，串口程序。-12864 LCD pic16f on, ad conversion process, the clock display program, serial program.