phone_recorder

这是我的开发板的原理图，希望能对大家有帮助 -This is my development board schematic diagram of the hope that it can be helpful to everyone

实现2路电压采集，采用ADC0808实现，C51编程，有proteus仿真！有较详细的程序注释。采用共阴数码管实现。程序中的串口设置可用在调试时使用。

硬件的cpu是arm920i2c总线和camera之间的连接驱动在嵌入式linux操作系统下编写-hardware cpu is arm920i2c bus and camera link between the driver in embedded Linux operating system prepared

PIC系列单片机典型应用程序集: BCD2BIN-PIC MCU sets typical applications: BCD2BIN

lpc2100_arm_keil实例,很好的实例，我用过-lpc2100_arm_keil examples, good example, I used

Security applicaion using CAN protocol

CPLD初始化程序,用于DSP5416与SAA7111A的时序控制初始化.-CPLD initialization procedure for the DSP5416 and the timing control SAA7111A initialization.

在DOS13号中断下开发图形显示程序的例程，很经典的示例。-interruption in its DOS13 developed procedures graphics routines, classic examples.

这是一个 在S3C44B0板子,基于UClinux的网络传输程序,send.c是发送AD采集的数据(SEND.C带有AD采集程序).SET.C是设置程序比如采集时间等等.-This is a one in S3C44B0 plank, based on the network transmission UClinux procedures, send.c sending data acquisition AD (AD SEND.C with acquisition procedures). SET.C is located Purchase procedures such as collecting time and so on.

FPGA设计，PCI的IP核，很好的源代码，供大家参考！