MzT24_Driver_C8051 用KEIL写的

单片机的程序，关于串口通讯的，对初学者来说说不定有用。-SCM procedures, on the serial communication, and may be useful for beginners.

采用MCP2515的CAN通信代码，适合8位、16位AVR单片机-MCP2515 using the CAN communications code, suitable for 8-bit, 16-bit AVR Singlechip

电路实验，密码锁，详细的实验报告，好东西，多多分享-Experimental circuit, password lock, a detailed experimental report good things, a lot to share

用1片164动态驱动6个数码管，实现数字时钟功能-164 with a dynamic drive six digital control, digital clock function

430单片机的NRF905的驱动 调试已经通过 保证可以使用 msp430f147-430 SCM NRF905 debugging has been driven by guaranteeing use msp430f1 47

华邦winbond单片机头文件，使用winbond单片机时需包含在原文件中

MSP430-LCD1602液晶显示驱动程序，MSP430-LCD1602液晶显示驱动程序-MSP430-LCD1602 LCD driver, MSP430-LCD1602 LCD driver

利用51单片机及其接口电路模拟DMA的控制过程，由于数据的传输实际上不经过CPU而直接由A/D转换芯片传送到存储器，从而实现了数据的高速传送。-The use of 51 single-chip circuit simulation and its interface DMA control process, because the data transmission does not actually read the CPU and directly from the A/D conversion chip is sent to memory, thus realizing high-speed data transmission.

用L298作为驱动器，控制两相混合式步进电机。 按键从上至下分别为减速，加速，正转，反转，停止。 具体参数还没有设定过。速度有些慢，加速按2下有效，然后就不能再快了。 转速输出是按照最小系统版的数码管写的。电路图里太麻烦就没画了。-Using L298 as the drive to control two-phase hybrid stepping motor. Buttons from top to bottom respectively, deceleration, acceleration, are being transferred, reverse, stop. Specific parameters have not yet been set. Some of the slow speed, speed up by 2, effectively, and then can not be faster. Speed output is in accordance with the minimum system version of the digital tube wrote. Circuit where not too much trouble drew.

一个我刚工作时用Ｃ语言编写的单片机数据采集卡的代码-one I just work with C language of SCM data acquisition card code