tlc5615 drivers. Procedures used were relatively good, and very pleased to share...

程序由C语言编写，时序完全达到要求，含有proteus仿真图。硬件上已经测试通过！-Procedures by the C language, timing fully meet the requirement, contained Proteus simulation of Fig. Hardware has been tested!

LT_1B msp430开发板例子程序－TB6

可控硅及其触发系统的文章具有一定的参考价值-SCR and its trigger system of the article has a certain reference value

DTMF双向收／发集成电路MT8880专门为双音频信号的收、发而设计，它既能产生发送双音频信号，又能对双音频信号进行接收译码，还能判断各种信号音(拨号音、回铃音、忙音)。以上就是它的应用电路和程序-Two-way DTMF collection/fat MT8880 IC specifically for the dual audio signals received, the design, it could have sent dual audio signal, while the dual audio signal decoding receiver, but also to judge the sound signal (dial tone , ring back tone, busy tone). Above is its application circuit and procedures

这个是汽车制动台控制程序的C语言版本. 用于实际产品中.单片机用的是PIC16F877A.-This is automobile brake control procedures Taiwan version of the C language. For the actual products. Singlechip using PIC16F877A.

TFT液晶屏测试程序，CPU为W77E58，修改发送指令可在液晶屏上显示不同的字符或图形-TFT LCD screen test procedures, CPU W77E58 to amend the directive to be sent on LCD screen show different characters or graphics

一个用单片机控制饲服电机的程序，采用ＯＭＲＯＮ光纤感应器实现的剪纸机，已通过调试-By feeding a single-chip microcomputer to control the electrical service procedures, the use of fiber-optic sensor OMRON realize the paper-cutting machines, has passed through debugging

I2C的程序 数据传送 非常详细的注释 C语言的 其他的就不用多说了吧-I2C data transmission procedures very detailed notes of the C language other on the right to say the least

基于DS12R885的时钟芯片的单片机程序 很具有参考价值-DS12R885-based single-chip clock chip is a reference value of the procedure

PHILIPS P87C591 PeliCan C语言开发库，极大方便了对591的CAN开发。-PHILIPS P87C591 PeliCan C language library, a great convenience for the development of CAN 591.