这个是H.264解码部分4*4直流的反量化的ARM汇编程序,上面的那个IQ2_DC.rar是色度部分的反量化....

进行arm－linux嵌入式系统开发时，需要将文件烧写到flash上，在网上可以找到win下的烧写程序，但多数情况下开发环境应该是在linux下，烧写程序时切换到win下很不方便，使用该程序可以在linux下直接对flash进行烧写 该程序运行后将一个小的for arm的c程序通过串口传送到arm开发板上，使用该小程序与主机端通信，将主机传送信息烧写到flash上- Carries on when arm- linux inserts the type system development, needs the document fever to write on flash, is on-line may find under win the fever to write the procedure, but in the most situations the development environment should be under linux, the fever writes when the procedure cuts under win not to be very convenient, uses this procedure to be allowed directly to carry on the fever under linux after flash to write this procedure movement to transmit orally a small for arm c procedure through the string delivers on the arm development board, uses this script and the main engine end correspondence, writes the main engine pass-along message pam fever on flash

atmelsam7s64驱动3310液晶屏源代码-atmelsam7s64 3310 LCD driver source code

ARM 嵌入式系统 LPC22xx PWM 双边沿输出实验程序-ARM Embedded System bilateral LPC22xx PWM output experimental procedures along

2812使用spi读写fm25cl64或者at25640的程序，已经测试通过。注意在在eeprom的datasheet中都写只支持spi的0或者3模式，但我用0模式一直调不通，改用spi模式才可以，程序中就是使用spi的1模式。-2812 to read and write using spi or at25640 procedures FM25CL64 have the test. Attention to the datasheet in the EEPROM are write only support spi mode 0 or 3, but I used the 0 model has been adjusted barrier before they can switch to spi mode, process is the use of one mode of spi.

EasyARM2131开发板源码之一-----------2．GPIO输出实验－单路LED控制-EasyARM2131 one source development board----------- 2. GPIO output experiment- one-way LED control

AVR ATmega128L的LCD程序-AVR ATmega128L the LCD process

TI 元器件 SCH 封装 potel -SCH Packaging TI components potel

ARM程序设计-ARM程序设计基础,S3C4510B-ARM program design-ARM program design basis, S3C4510B

本测试程序是在44B0板子附带的LCD程序例子修改而来-This test procedure is included in the 44B0 board examples of changes from the LCD program

基于S3C44B0X芯片的UIP网络协议栈的设计源代码，该代码可以实现TCP、UDP、web等协议。-S3C44B0X chips based on the UIP design network protocol stack source code, the code can be TCP, UDP, web and other agreements.