mc9s12XDP512 单片机SCI0 程序

uCOSII for lpc2366开发模板-uCOSII for lpc2366 development of a template

并口Jtag 烧写flash工具的源代码-burning flash source tools

立于泰开发资料学习用，如发生侵权纠纷概不负责。-The development of an information to learn Thai, such as occurs takes no responsibility for infringement disputes.

一款在s3c44b0上运行通过的mp3解码程序-MP3 decoder sampling code which is based on S3C44B0

一种ARM控制下的步进电机的加速控制的源代码-ARM under the control of a stepper motor acceleration control of the source code

CCS环境下的关于DSP TMS320LF2403APAGA 的flash项目文件。-CCS environment on the flash DSP TMS320LF2403APAGA items Head document.

用IAP实现的flash操作，此源码运行于LPC2131等开发板-IAP implemented with flash operation, the source code running on the LPC2131 development board, etc.

C8051F 读写24C01 使用SMBus硬件端口-c8051f read and write 24c01 with smbus port.

redboot在Tensilica平台上的源码-redboot in the Tensilica platform source

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (