详细介绍 智能仪器的基本数据处理算法 适合系统学习的人员 仅供参考...

93CXX的驱动程序-93CXX driver

c8051f020的I2C程序，已经通过调试-c8051f020 the I2C procedures have been adopted to debug

实现IEEE802。15。4协议的开发板的USB驱动，完成了高速数据传输-Realize IEEE802. 15. 4 protocol development board

基于ADEK-PC实验系统多路温度信号（0~85℃）数据测量采集系统-based ADEK-PC experimental system of multi-channel temperature signal (0 ~ 85 C) measurement data acquisition system

485多机通信例程,很好用,适当修改可做单机使用-no

HID sample code for HOLTEK

５１单片机开发之　i2c中线的编程设计-Development of 51 single-chip i2c midline of Programming

我做的超声波测距程序，基于at的8位单片机的，用c语言编写的。-I do ultrasonic distance measurement procedure, based at the 8-bit microcontroller, using c language.

红外通信是利用950nm近红外波段的红外线作为传递信息的媒体，即通信信道。发送端采用脉时调制（PPM）方式，将二进制数字信号调制成某一频率的脉冲序列，并驱动红外发射管以光脉冲的形式发送出去；接收端将接收到的光脉转换成电信号，再经过放大、滤波等处理后送给解调电路进行解调，还原为二进制数字信号后输出。-Infrared communication is the use of near infrared 950nm infra-red as the transmission of information media, namely communication channel. The sending end when the use of pulse modulation (PPM) approach will be a binary digital signal into a frequency modulation of the pulse sequence, and driver fired infrared tube to the form of light pulses sent receiver will receive the pulse of light conversion to electrical signals , and then, after amplification, filtering and other treatment to the demodulation circuit after demodulation, reduced to a binary digital signal after the output.

老外写的基于arm的sd/mmc读写程序，开源的项目-foreigner was based arm of sd/-3.4 reading and writing procedures, open-source project