SCM calendar clock procedures

时钟芯片ds12c887线片驱动程序，可直接应用-Clock Chip ds12c887-ray driver, can be directly applied

本程序压缩和解压缩WAV16BIT ADPCM 文件 原程序,可以移到任何硬件平台 使用 本程序在PC和32位单片机系统运行良好 -the compression and decompression procedures WAV16BIT ADPCM original document procedures can be moved to any hardware platform and the use of the procedures in the PC and 32-bit microcontroller system operated we

2401_Quick_Dev无线模块的源代码_source code for 89LV51-2401_Quick_Dev wireless module

LCD 0108驱动程序 -LCD Driver for LCD 0,108 0,108 0,108 LCD Driver for LCD Driver 0108 Driver

这是一个时钟中断的小程序-This is a small clock interrupt procedures

基于ATMEGA128控制的DS18B20的温度显示，采用LED显示。-ATMEGA128-based control DS18B20 the temperature display, LED display.

UCOS2在51上的移植源码V1.1。学习UCOS的代码-UCOS2 51 on the transplant source V1.1. UCOS learning code

ch451的使用，遇到问题可以参考 做spi驱动-ch451 use problems can refer to make spi driver

蜂鸣器响 改变蜂鸣器的频率，通过改变延时时间 蜂鸣器的时间要是是靠延时来完成的-Buzzer buzzer ring to change the frequency by changing the delay time if the buzzer is the time to be completed by the time delay

单片机系统上电后，P0 口和 P1 口都被清 0。然后，你规定一个由 6 个数字构成的序列（每个数字从 0～F 中选取），比如 E、8、9、0、7、F。然后每次当单片机检测到外部中断 0发起中断时间时，读取 P0 口和 P1 口上的状态值，当连续 6 次外部中断事件的对应的数字序列构成你所设定的序列后（举例来说，如果 P0.0 是 1，P0 和 P1 的其他管脚是 0，那么我们称为检测到一次数字 0），从串口打印输出一幅类似下图的 16×16 的ASCII码的圣诞树图片。-Single-chip microcomputer system after power, P0 and P1 mouth I have been ching 0. Then you set a six figure constituted by the sequence (each number from 0 ~ F in selected), for example, E, 8,9,0,7, F. And then each time a single-chip detects external interrupt 0 initiated interruption time, I read the P0 and P1 mouth on the state value, when a row 6 times the corresponding external interrupt events constitute digital sequence set your sequence (for example example, if P0.0 is 1, P0 and P1 of the other pin is 0, then we called a number of detected 0), a printout from the serial port under similar 16 × 16 map of the ASCII code of the Christmas tree图片.