SM5964 ISP program. .........

用可调电阻调节电压值作为模拟温度的输入量，当温度低于30℃时，发出长嘀报警声和光报警，当温度高于60℃时，发出短嘀报警声和光报警。测量的温度范围在0－99℃。-Adjustable voltage regulator with resistance values of the input analog temperature, when the temperature is below 30 ℃, the issue of longalarm sound and light alarm, when the temperature is higher than 60 ℃, short issuedalarm sound and light alarm. Measurement of the temperature range of 0-99 ℃.

基于51的使用步进电机控制升旗程序c语言-Stepper motor control based on the 51 flag-raising program c language

基于80C51的一个例子程序,实现了流水灯操作-an example of the process and realized the water lights operation

定时器中断实验代码， 定时器3进行0.1秒定时，每0.5秒改变一次P2,P3口的值以产生走马灯效果。-timer interruption experimental code, three timers for 0.1 seconds regularly, every 0.5 seconds to change a P2, P3 to the values I have merry-go-round effect.

我自己编写的74HC595数码管显示程序,一个595驱动两个共阳极数码管-I have written 74HC595 digital tube display program, a total of 595 drive two digital tube anode

一个基于STC89LE516单片机测温程序,-STC89LE516 based on single-chip temperature measurement procedures,

MAGIC2103-ARM7开发板中的UART源程序代码-MAGIC2103-ARM7 development board of the UART source code

PWM Keil C51 零耗时低频宽脉冲软PWM信号控制Keil C51演示程序-PWM Keil C51 zero time-consuming and low-bandwidth pulse soft PWM signal control Keil C51 demo program

很好的源代码,x250汇编源码,X250读写功能,-good source code, compile source SCH-X250, SCH-X250 features,

基于DS18B20的数字温度检测系统的程序设计 通过验证-DS18B20 figure based on the temperature of the detection system design through the verification procedure