c8051F020 液晶显示的程序 也许有用

c8051f单片机外接ht1380，关于时间的读取，设置-c8051f MCU external ht1380, on the time to read, set

单片机正弦信号产生中改变正弦消耗频率时仍然保持采样频率的算法-SCM sinusoidal signal to change consumption frequency sinusoidal remained sampling frequency algorithm

该程序用于使CCP1模块产生分辨率为10位的PWM波形，占空比为50 */-该程序用于使CCP1模块产生分辨率为10位的PWM波形，占空比为50*/

适用于51单片机的万年历算法.rar-applied to the MCU 51 calendar algorithm. Rar

IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta

我自己刚刚做的一个频率计，不是很会！希望大家给我提意见-I have just done a frequency counter, it will not! I hope to put forward their views

Uart串口自发送程序,单片机自动给上位机传送数据-Usart auto send data

研究所积累的资料5,大家秘密使用,千万别告诉别人!-5 Institute of accumulated data, we use a secret, please do not tell others!

At24c01的详细资料，希望对大家有用-At24c01 detailed information, in the hope that useful to everybody

基于51单片机的遥控电风扇的红外线接收程序-Based on 51 single-chip infrared remote control fans receiving procedures