430单片机的NRF905的驱动 调试已经通过 保证可以使用 msp430f147

12864+ds1302 的万年历，LCD是带中文字库的，串行-12864+ Ds1302 the perpetual calendar, LCD is intended to bring the Chinese font, serial

CAN上位机通讯程序vb与单片机通信时用的上位机程序 -CAN PC communication program vb and MCU communication procedures used in PC

心电信号的计算机分析毕业论文-ECG analysis of the computer Thesis

avr单片机用的，有源代码，原理图（包括JTAG和STK500）-avr Singlechip used, active code, schematics (including JTAG and STK500)

对利用595串行实现IO口扩展，本程序仅用3个IO口扩展到6个数码管-Realize the use of 595 serial IO port expansion, this procedure only 3 IO I extend to six digital tube

一个用于驱动TFT屏的驱动程序,使用IC:1828,program (无EEPROM 无IR,完整说明)IIC只写一个-driving a TFT screen for the driver, the use of IC : 1828. program (no EEPROM non-IR, a complete explanation) just write a IIC

80C51F020的SPI接口源码-80C51F020 SPI interface FOSS

51MCU在KEILUV3下开发的源代码，包括全部工程文件-51MCU in KEILUV3 developed source code, including all engineering documents

功能描述： 利用AT89S51单片机的T0、T1的定时计数器功能，来完成对输入的信号进行 频率计数，计数的频率结果通过8位动态数码管显示出来。要求能够对2－40KHZ 的信号频率进行准确计数，计数误差不超过2/1-Functional Description: Using AT89S51 MCU T0, T1 timing counter function, to complete the input signal frequency counting, counting the frequency of 8 resulted in the adoption of dynamic digital tube display. Request to the 2-40KHZ signal frequency accurately count, counting error of less than 2/1

液晶显示器与单片机接口电路程序，实现液晶显示对于信号源发生信号的控制和显示-LCD and microcontroller interface circuit procedures, LCD occurred signal source for the control signal and display