51 VERILOG code! In Xilinx FPGA

8051 Serial I/O Routines Ring buffered, interrupt-driven UART driver, written in Keil C .

运行于c51单片机上的用keil c创建的C源程序,采用PDIUSBD12接口。-run on the microcontroller with Keil c create C source code using PDIUSBD12 interface.

任意波形电源逆变脉冲控制器，使用单片机做控制器，C语言编程-Arbitrary waveform pulse power inverter controller, make the use of single-chip controller, C language programming

这是在SL811上实现的对U盘进行FAT32或FAT16读写的程序，用于51单片机-This is achieved in the SL811 to the U to FAT32 or FAT16 disk to read and write procedures for the 51 single-chip microcomputer

HT44780 液晶显示驱动 里面有简单 程序和说明-HT44780 driver inside the liquid crystal display has a simple procedure and description

在Windows环境下应用VC++实现PC机与单片机的几种串行通信方法，给出了用Visual C++6.0编写的PC机程序和用C51编写的单片机通信程序。经实际应用系统运行稳定可靠。-In the Windows environment application VC++ Realize PC machine with several single-chip serial communication method using Visual C++ 6.0 prepared PC-preparation procedures and the use of C51 microcontroller communication program. Through the practical application of system operation is stable and reliable.

基于单片机的程序，利用18B20测温，并通过1602液晶显示，并有检测18B20是否正常工作的功能。-Based on SCM procedures, the use of 18B20 temperature, and liquid crystal display 1602, and 18B20 Detect Whether or not there is a normal job functions.

利用动态扫描和定时器1在数码管上显示 出从765432开始以1/10秒的速度往下递减 直至765398并保持显示此数，与此同时利 用定时器0以500MS速度进行流水灯从上至 下移动，当数码管上数减到停止时，实验 板上流水灯也停止然后全部开始闪烁，3秒 后（用T0定时）流水灯全部关闭、数码管上 显示出"HELLO"。到此保持住。 设晶振频率为12MHz。-The use of dynamic scanning and Timer 1 in the digital control to show from the beginning of 765,432 to 1/10 seconds until the speed of descending down 765,398 and maintain display this number, at the same time the use of Timer 0 to 500ms the speed of light from the flowing water to Under the move, when reduced to a few digital tube stop, the experiment on-board water stop and then all the lights started to flicker, 3 seconds later (T0 regularly used) closed water lights, digital tubes show

320240液晶中文字库，如果没有内置字库，应该有一定的参考价值-LCD 320,240 Chinese font, if there is no built-in font, there should be some reference value

本程序是一师兄给我的，用于液晶屏的滚动显示，给大家参考参考-this is a process, told it to me, for the rolling screen, to your information.