12864 液晶驱动程序 里面是个测试程序，内容比较简单！

芯片HT1623驱动段码液晶屏显示；通过开辟显存区；利中断定时刷新三排数码管显示；-Chip HT1623 Drive Segment LCD display through the creation of memory area Lee interrupted refresh three rows of digital tube display

把程序写进单片机从而控制电梯的上下，开关门，报警等功能！这个程序简单，使用性强！-procedures written into the MCU control of the elevator up and opening the doors, alarm functions! This simple procedure, the use of strong!

PROTUES是个高效率的在线仿真软件,该锦集为在线仿真的应用.里面的资料,包含了各个内容的原程序和原理图等.

控制电机运动的G代码程序,如果对G代码不清楚,请先看懂G代码,然后再看本程序.-Control motor movement, G code program, if the G code is not clear, please understand G code, and then look at the procedures.

单片机读写TDA8007，比较简单，可做参考。-Read and write single-chip TDA8007, relatively simple, can refer to.

AT89c51单片机7279驱动键盘数码管程序-7279 driver keyboard AT89C51 single-chip digital control procedures

1―wire总线的详细介绍，对有设计硬件电路的同志有帮助-1-wire bus detailed description of the hardware design of a circuit to help comrades

52单片机的ucos移植程序，需要外加ram。比较通用。-52 Singlechip uCOS transplantation procedures, the need for additional ram. More generic.

AVR 4*4键盘输入并通过USART进行通讯-AVR 4* 4 keyboard to communicate through USART

在1602上显示时间计时，已经测试，好用-Display time in the 1602 time has been tested, easy to use